Table of Contents
Advertisement
Press Close to discard the setting and return to Fig 3.24
Press Open to save the setting and return to Fig 3.24.
3.6.9 Heater Setting
From the dome setting 2 menus shown in Fig3.17, move joystick and move cursor to HEATER
SETTING, press Open to enter the following menu (Figure 3.28).
HEATER DISPLAY:
Heater display shows heater state.
ON: Screen will display heater state.
OFF: Screen will not display heater state.
HEATER MODE:
Heater mode is to set the heater's startup mode.
AUTO: Heater starts when temperature is lower than lower temperature.
OFF: Heater is closed.
ON: Heater is open.
TEMPERATURE SET:
Temperature set is to set the heater's startup temperature.
Operations:
1. Move joystick to select an item.
2. Press Open.
3. Move the stick to select a parameter.
4. Press Open.
3.6.10 Cruise Setting
From the menu shown in Fig3.17, move joystick to select <CRUISE SETTING>, press Open to
Bernee Auto Tracking Dome Camera User Manual
HEATER SETTING
HEATER DISPLAY
HEATER MODE
TEMPERATUEE SET
BACK
EXIT
Figure 3.28 HEATER SETTING
35 / 39
ON
AUTO
33℃
Advertisement
Table of Contents
