Table of Contents
Advertisement
After powered up, the dome will conduct reset procedure. In this procedure, the dome firstly pans to
the default horizontal origin point, and finally tilts to the vertical 45° position to complete the self-testing.
After the dome stops, it means the camera has completed the self-testing and is ready to receive control
commands.
(2) Pan and tilt: Move joystick up, down, right, left.
(3) Set up preset
Move to next position. Then press PRESET + NUM （preset NO.） + ENTER and the dome will save
current horizontal angle and title angle of pan / tilt / zoom and position parameters into memory.
(4) Call preset
Press PRESET + NUM（Preset NO.）+ ENTER , and the dome will calls these parameters saved in
memory and adjust Pan/Tilt/Zoom of the camera to that position.
Presets 1
80
Auto tracking
82
Auto switch sequentially among preset positions
83
Clear all presets positions
95
Select main programming menu
97
Random scanning
98
Frame scanning
99
Start auto scanning
Note: For others dynamics controllers with only 64 or 40 presets. On the menu of PRESETS
NUMBER, set it as 64 or 40. Then you can use presets listed in 'Presets 2' instead.
(5) Zoom: You can press IN or OUT key continuously or revolve the joystick to get desired zooming
times.
(6) Focus: press FAR or NEAR key.
(7) Iris: Press OPEN or CLOSE key.
Bernee Auto Tracking Dome Camera User Manual
Extended Presets
Function
12 / 39
Presets 2
37
19
20
28
30
31
32
Advertisement
Table of Contents
