Table of Contents
Advertisement
Additional Information
Understanding auto TA and EQ error messages
When correct measurement of car interior acoustic characteristics is not possible using the auto
TA and EQ, an error message may appear on the display. If an error message appears, refer to the
table below to see what the problem is and the suggested method of correcting the problem. After
checking, try again.
Message
Error. Please check MIC.
Error. Please check front SP.,
Error. Please check FL SP.,
Error. Please check FR SP.,
Error. Please check center SP.,
Error. Please check rear SP.,
Error. Please check RL SP.,
Error. Please check RR SP.,
Error. Please check subwoofer
Error. Please check noise.
iPod is not charged but operates
correctly
The connected USB portable audio
player/USB memory consumes
more than 500 mA (maximum allow-
able current).
Error has occurred when connect-
ing the iPod to this unit
Cause
Microphone is not connected.
The microphone cannot pick up the
measuring tone of a speaker.
The surrounding noise level is too
high.
Check if the connection cable for iPod
shorted out (e.g., not caught in metal ob-
jects). After checking, turn the ignition switch
OFF and back ON or disconnect the iPod and
connect again.
Check if the connection cable for iPod
shorted out (e.g., not caught in metal ob-
jects). After checking, turn the ignition switch
OFF and back ON or disconnect the iPod and
connect again.
Reconnect the iPod.
Turn the ignition switch to OFF, then to ACC
or ON.
Update the iPod version.
Action
Plug the supplied microphone securely into
the jack.
! Confirm that the speakers are connected
correctly.
! Correct the input level setting of the power
amp connected to the speakers.
! Set the microphone correctly.
! Stop your car in a place that is as quiet as
possible, and switch off the engine, air condi-
tioner or heater.
! Set the microphone correctly.
CRB2974-A/N
<
>83
Appendix
83
En
Advertisement
Table of Contents
