Additional Information; Understanding Built-In Cd Player Error Messages; Understanding Auto Ta And Eq Error Messages; Understanding Error Message On Rewriting The Entertainment Displays - Pioneer Super Tuner III D DEH-P8600MP Operation Manual

Additional Information

Understanding built-in CD
player error messages
When problems occur during CD play an error
message may appear on the display. If an
error message appears, refer to the table
below to see what the problem is and the sug-
gested method of correcting the problem. If
the error cannot be corrected, contact your
dealer or your nearest Pioneer Service Center.
Message Cause
ERROR-11, 12, Dirty disc
17, 30
ERROR-11, 12, Scratched disc
17, 30
ERROR-10, 11, Electrical or me-
12, 17, 30, A0 chanical
ERROR-22, 23 The CD format
cannot be played
back
ERROR-44 All tracks are
skip tracks
Understanding auto TA and
EQ error messages
When correct measurement of car interior
acoustic characteristics is not possible using
the auto TA and EQ, an error message may ap-
pear on the display. If an error message ap-
pears, refer to the table below to see what the
problem is and the suggested method of cor-
recting the problem. After checking, try again.
All manuals and user guides at all-guides.com
Action
Clean disc.
Replace disc.
Turn the ignition
ON and OFF, or
switch to a differ-
ent source, then
back to the CD
player.
Replace disc.
Replace disc.
Message Cause
Error check Microphone is
MIC not connected.
Error check The microphone
front SP, Error cannot pick up
check FL SP, the measuring
Error check FR tone of a speaker.
SP, Error check
RL SP, Error
check RR SP,
Error check
SW
Error check The surrounding
noise noise level is too
high.
Understanding error
message on rewriting the
entertainment displays
When problems occur during rewriting the en-
tertainment displays an error message may
appear on the display. If an error message ap-
pears refer to the table below to see what the
problem is and the suggested method of cor-
recting the problem. If the error cannot be cor-
rected, contact your dealer or your nearest
Pioneer Service Center.
Message Cause
CD ERROR CD player error
Appendix
Action
Plug the supplied
microphone se-
curely into the
jack.
! Confirm that the
speakers are con-
nected correctly.
! Cancel muting
the front speaker
units.
! Correct the input
level setting of the
power amp con-
nected to the
speakers.
! Set the micro-
phone correctly.
! Stop your car in
a place that is as
quiet as possible,
and switch off the
engine, air condi-
tioner or heater.
! Set the micro-
phone correctly.
Action
Press EJECT and
check the disc.
65
En