Install Remote Light - Chamberlain 3800C Owner's Manual

IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of SEVERE INJURY or DEATH:
1. This portable luminaire has a polarized plug (one blade is
wider than the other) as a feature to reduce the risk of
electric shock.
2. This plug will fit in a polarized outlet ONLY one way.
3. If the plug does not fit fully in the outlet, reverse the plug.
4. If it still does not fit, contact a qualified electrician.
INSTALLATION STEP 6

Install Remote Light

The remote light is designed to plug directly into a
standard 120V outlet.
1. Install the hinge and latch clips. Clips slide in between
the metal plate and the plastic housing on each side of
the light base (Figure 1).
2. Select appropriate location on the ceiling to mount the
light wihin 6' (1.8 m) of an electrical outlet so that the
cord and light are away from moving parts.
3. Install the mounting plate with the screws provided.
Leave 1/8" (3.1 mm) of thread exposed between the
ceiling mount plate and the screw thread.
NOTE: If installing remote light on drywall and a ceiling
joist can not be located, use wall anchors provided.
No pilot hole is required for wall anchors.
4. Determine the length of power cord needed to reach
the nearest outlet. Wind any excess cord around cord
retainer on the top side of the light base.
5. Install the light base by pushing onto the screws and
turning the base clockwise to lock the light in place.
6. Install two Type A19 incandescant or compact
fluorescent bulbs. 100 watt maximum per bulb,
200 watts total.
7. Install the light lens by hooking one end of the lens
over the hinge and pressing up on the other end to
latch into place (Figure 3).
8. Plug in the light to outlet.
NOTE: Light will not operate until the unit is activated.
HARDWARE SHOWN ACTUAL SIZE
Light Clip Screw
#4-20 X 7/16" (2)
Screw #6x1" (2)
Wall Anchor (2)
WARNING
5. NEVER use with an extension cord unless plug can be
fully inserted.
6 DO NOT alter the plug.
7. Light is intended for ceiling mount and indoor
applications ONLY.
To prevent possible OVERHEATING of the light socket,
• DO NOT use short neck or specialty light bulbs.
• DO NOT use halogen bulbs. Use ONLY incandescent or
compact fluorescent bulbs
Figure 1
Plastic
Housing
Figure 2
Figure 3
11
WARNING
CAUTION
Light Clip Screw
Latch Clip
Metal
Plate
Cord Retainer
Light
Lens
Light
Base
Hinge Clip
Light Clip
Screw
Wall Anchors
Mounting
Plate
Screws