Install Remote Light - Chamberlain RJO20 Manual

Installation
(continued)
IMPORTANT INSTALLATION INSTRUCTIONS
To reduce the risk of SEVERE INJURY or DEATH:
1. This portable luminaire has a polarized plug (one
blade is wider than the other) as a feature to
reduce the risk of electric shock.
2. This plug will fi t in a polarized outlet ONLY one
way.
3. If the plug does not fi t fully in the outlet, reverse
the plug.
9

Install Remote Light

The remote light (garage door opener
light) is designed to plug directly into
a standard 120V outlet. Select an
appropriate location on the ceiling to
mount the light within 6 feet (1.83 m)
of an electrical outlet so that the cord
and light are away from moving parts.
1. Install the hinge and latch clips.
Clips slide in between the metal
plate and the plastic housing on
each side of the light base.
2. Install screws into the ceiling leaving
1/8 inch (3 mm) of the thread
exposed.
NOTE: If installing light on drywall and
a ceiling joist cannot be located, use
drywall anchors provided. No pilot
hole is required for drywall anchors.
3. Wind any excess cord around cord
retainer on the top side of the light
base.
4. Install the light base by pushing
onto the screws and turning the
base clockwise to lock the light in
place.
5. Install two Type A19 incandescent
or compact fl uorescent bulbs (100
watt maximum per bulb, 200 watts
total).
NOTE: Do not use LED bulbs as they
may reduce the range or performance
of your remote control(s).
6. Install the light lens by hooking one
end of the lens over the hinge and
pressing up on the other end to latch
into place.
7. Plug in the light to outlet.
NOTE: Light will not operate until
the garage door opener is activated.
Multiple openers in the same garage
may cause interference between lights.
Program all lights to one opener to
avoid interference.
HARDWARE
Drywall Anchor (screw-in) (2)
Screw #6x1" (2)
Screw #4-20x7/16" (2)
Cord
Retainer
Antenna needs to be
fully exposed to prevent
intermittent light
behavior.
Latch Clip
Metal
Plate
Plastic
Housing
16
4. If it still does not fi t, contact a qualifi ed
electrician.
5. NEVER use with an extension cord unless plug
can be fully inserted.
6. DO NOT alter the plug.
7. Light is intended for ceiling mount and indoor
applications ONLY.
To prevent possible
OVERHEATING of the end panel or
light socket:
• DO NOT use short neck or
specialty light bulbs.
• DO NOT use halogen bulbs. Use
ONLY incandescent.
• DO NOT use bulbs larger than
100W.
• ONLY use A19 size bulbs.
To provide an adequate visual
alert, the garage door opener light
bulb MUST be a minimum of 40
Watt (or equivalent).
Wall Anchor
Light Clip
Screw
Screws
Light Base
Hinge Clip
100 Watt
(max.)
Light Lens