Using The Wall-Mounted Control Console - Chamberlain 3800C Owner's Manual

Using the Wall-Mounted
Control Console
THE MOTION DETECTING CONTROL CONSOLE
Press the push bar to open or close
the door. Press again to reverse the
door during the closing cycle or to
stop the door while it's opening.
This control console contains a
motion detector that will
automatically turn on the light when
it detects a person entering the
garage. This feature can be easily
turned off for extended work
light use.
Remote Light feature
When using the remote lights as working lights, we
recommend that you first disable the motion sensor. See
Automatic Light Feature, following.
Automatic Light Feature: The opener light will turn on
automatically when a person enters the garage. When a
person walks in front of the control console, the light will
come on for 3-1/2 minutes, then shut off. This feature
works by detecting body heat and may not work in
temperatures around 100˚F (37.7˚C).
To disable this feature, slide the Detector Switch on the
right side of the control console down (off).
We recommend that you disable the motion sensor when
using the opener lights as working lights. Otherwise, they
will turn off automatically if you are working beyond the
sensor's range.
Lock feature (Control console lock only, not power
door lock)
Designed to prevent operation of the door from
hand-held remote controls. However, the door will open and
close from the Control Console, the Outside Key lock and
the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2 seconds.
The push bar light will flash as long as the Lock feature
is on.
To turn off, press and hold the Lock button again for
2 seconds. The push bar light will stop flashing. The Lock
feature will also turn off whenever the "Learn" button on the
motor unit panel is activated.
Additional features when used with the 3-Button
hand-held remote
A) To control the opener lights:
In addition to operating the door, you may
program the remote to operate the lights.
1. With the door closed, press and hold a
small remote button that you want to control the light.
2. Press and hold the Light button on the control console.
3. While holding the Light button, press and hold the Lock
button on the control console.
4. After the opener lights flash, release all buttons.
B) To operate one door using all three buttons on the
hand-held remote:
Push
Bar
Detector
Switch
Lock
Light
Button
Button
22
You may program the remote to open the door with the
large button, close it with the middle button, and stop the
door's movement with the third button.
NOTE: If remote is already programmed, you must first
erase all codes. See Programming.
1. With the door closed, press and hold the large remote
push button.
2. Press and hold the Lock button
on the door control
for a minimum of one second
before proceeding to next step.
3. Press and hold the door control
push bar.
4. After the opener lights flash, release all buttons.
Open
Close
Stop