Electrical Requirements; Installation Instructions; Unpack The Refrigerator Drawers; Remove The Base Grille - KitchenAid KDDA27TRS00 Installation Instructions Manual

Iftheflooroftheopening i snotlevel w iththekitchen f loor,
shim theopening tomake itlevel w iththekitchen f loor.
\
I
I
I
I
INSTALLATION
INSTRUCTIONS
Excessive Weight Hazard
Use two or more peopme to move and install refrigerator
drawers.
Faimure to do so can resumt in back or other injury.
Remove the Packaging
Properly dispose of packaging. Do not use sharp instruments,
rubbing alcohol, flammable fluids, or abrasive cleaners to remove
tape or glue. These products can damage the surface of your
refrigerator drawers.
IMPORTANT: Use a T30 TORX ®t screwdriver to remove the
skids.
Emectdcal Shock Hazard
Pmuginto a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can resumt in death,
fire, or electrical shock.
Before you move your refrigerator drawers into the final location,
it is important to make sure you have the proper electrical
connection.
Recommended grounding method
A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator drawers be provided. Use an
outlet that cannot be turned off by a switch. Do not use an
extension cord.
IMPORTANT: If this product is connected to a GFCI
(Ground Fault Circuit Interrupter) protected outlet, nuisance
tripping of the power supply may occur, resulting in loss of
cooling. Food quality and flavor may be affected. If nuisance
tripping has occurred, and if the condition of the food appears
poor, dispose of it.
When Moving Your Refrigerator Drawers:
Your refrigerator drawers are heavy. When moving the
appliance for service, be sure to protect the floor. Always
pull the appliance straight out when moving it. Do not
wiggle or "walk" the appliance when trying to move it, as
floor damage could occur.
Clean Before Using
After you remove all of the package materials, clean the inside of
your refrigerator drawers before using them. See the cleaning
instructions in the Use & Care Guide.
t t,s, _::;
IMPORTANT: You must remove the base grille in order to lower
the leveling legs. Be sure to reinstall the base grille when the
installation is complete.
1. Using a Phillips screwdriver, remove the four screws from the
base grille as shown.
NOTE: Do not discard the screws.
A
A
A. Screws
Place the base grille on a clean, soft working surface for
later use.
t®TORX is a registered trademark of Textron Innovations Inc.