Installation; Replacement Parts - Kenmore 41744102301 Installation Instructions Manual

2.
3.
4.
5.
6.
7.
INSTALLATION
Run some water from the hot
and cold faucets to flush the
water lines and remove
particles that might clog up
the water valve screens.
Remove the inlet hoses and
rubber washers from the
plastic bag and install the
rubber washers in each end
of the inlet hoses.
(90 ° elbow end) Carefully
connect the inlet hose marked
"HOT" to the outside "H" outlet
of the water valve. Tighten by
hand, then tighten another
2/3 turn with pliers.
Connect the inlet hose ends to the HOT and COLD
water faucets tightly by hand, then tighten another 2/3
turn with pliers. Turn the water on and check for leaks.
NOTE: Use only new hoses provided with this unit.
Carefully move the washer to its final location. Gently
lift up on the front of the washer and slide back.
NOTE: Lifting up more than 1/8" will engage the rear
legs. Do not use the dispenser drawer or door
to lift washer.
With the washer in its final position, place a level on
top of the washer (if an undercounter installation, no
rocking of the washer should exist). Adjust the front
leveling legs up or down to ensure the washer is
resting solid. Turn the lock nuts on each leg up towards
the base of the washer and snug with a wrench.
NOTE: Keep the leg extension at a minimum to
prevent excessive vibration. The farther out
the legs are extended the more the washer
will vibrate.
If the floor is not level or is damaged, the rear leveling
legs may have to be extended. For undercounter
installations, rear leg adjustment is accessible through
the front service panel.
Form a U shape on the end of the drain hose with the
hose pointed toward the drain. Place in a laundry tub
or standpipe and secure with the cable tie provided in
the enclosure package.
NOTE: If the drain hose is placed in a standpipe
without forming a U shape, a siphoning action
CableTie
Cable
Tie
Cable
Tie
could occur. There must be an air gap around the drain
hose. A snug hose fit can also cause a siphoning
action.
8. Plug the power cord into a grounded outlet.
NOTE: Check to ensure the power is off at a circuit
breaker/fuse box before plugging the power
cord into an outlet.
9. Turn on the power at a circuit breaker/fuse box.
10. Read the Operating instructions and Owner's Guide
provided with the washer. They contain valuable and
helpful information that will save you time and money.
11. Run the washer through a complete cycle. Check for
water leaks and proper operation.
12. If your washer does not operate, please review the
"Avoid Service Checklist" in your Owner's Guide before
calling for service.
13. Place these instructions in a location near the
washer for future reference.
NOTE: Awiring diagram is located inside the washer
on the service panel.
REPLACEMENT PARTS
If replacement parts are needed for your washer, call
Sears Parts and Service Toll Free Number 1-800-4-
MY-HOME
TM
(1-800-469-4663).
Destroy the carton and plastic bags
after the washer is unpacked. Children might use them
for play. Cartons covered with rugs, bedspreads, or
plastic sheets can become airtight chambers causing
suffocation. Place all materials in a garbage container
or make materials inaccessible to children.
The instructions in this manual and all
other literature included with this washer are not meant
to cover every possible condition and situation that
may occur. Good safe practice and caution MUST be
applied when installing, operating and maintaining any
appliance.
Maximum benefits and enjoyment are achieved
when all the Safety and Operating instructions are
understood and practiced as a routine with your
laundering tasks.