Step 7, Level Refrigerator; Step 8, Alternate Anti-Tip Procedure; Zkhss2 Tubular Handle Kit - GE ZISS480DXBSS Installation Instructions Manual

Installation Instructions
ISTEP 71LEVEL REFRIGERATOR
All models have 4-point leveling. The front is
supported by leveling legs, the rear is supported
by adjustable wheels. Both are accessible from
the front of the refrigerator.
, To level the back of the refrigerator, turn the 7/16"
hex nut located above the front wheels. Turn
clockwise to raise or counterclockwise to lower the
refrigerator.
, For front leveling, use a 1-1/4" open-end wrench.
Adjust height of refrigerator to match installation
cutout opening 85-1/2" to 84-1/2". The refrigerator
should be level and plumb with cabinetry.
Hex Nut Ad
Rear Wheels
CAUTION:
The rear leveling wheels and front leveling legs
are limited to a maximum height adjustment of 1".
If the installation requires more than 84-1/2" height,
the installer should elevate the refrigerator on a sheet
of plywood or runners. Cabinetry trim could also
be added across the top of the opening to shorten
the opening. If you attempt to raise the refrigerator
more than 1", you will damage the front leveling
legs and the rear leveling wheels. Make adjustments
in small increments.
PRUDENCE
Les roues de nivellement arri6re et les pattes de
nivellement avant permettent un r6glage maximal
de 25 mm (1 po). Si I'ouverture pour le r6frig6rateur
a une hauteur sup6rieure 6 2,15 m (8/4-!/2 po),
I'installateur dolt 61ever le r6frig6rateur sur une feuille
de contre-plaqu6 ou des glissi6res. II est 6galement
possible d'ajouter des baguettes de finition des
placards sur le haut de I'ouverture afin de la r6duire.
Lever le refrig6rateur de plus de 25 mm (1 po)
endommage les pattes de nivellement avant
et les roues de nivellement arriere.
ISTEP 8 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent tipping.
The anti-tip brackets cannot be used on metal
wall studs. Use this Alternate Procedure to secure
the refrigerator against tip-over whenever metal
wall studs are encountered and there is no soffit.
i'
_SIde View /
Top Case Trim _T_Op CaseTjri_
/ /--\ -
__ "_.\ \ / /
_-I/2" DrywallScrews
Through Trim and Into Soffit
or 3/4" Min.Wood grace
, Raise the grille panel to access case trim.
, Use a 3/16" bit to drill four evenly spaced clearance
holes through the metal top case trim.
Use a 1/16" bit to drill to pilot holes through the metal
clearance holes and into the wood soffit. The holes
should be centered in the soffit or a 3/4" min. wood
brace. The brace spanning the enclosure must
be securely fastened to cabinets on both sides.
Install four, 1-1/2" drywall screws into the pilot holes.
13