Step 6 Level Refrigerator; Step 7, Align Doors - GE ZFSB23D SS Installation Instructions Manual

STEP 6 LEVEL REFRIGERATOR

The refrigerator can be leveled by adjusting the
rollers located near the bottom hinges.
Rollers have three purposes:
• The rollers adjust so that the door closes easily
when opened about halfway. (Raise the front about
5/8" [16 mm] from the floor.)
• Rollers adjust so allow the refrigerator to be firmly
positioned on the floor and to prevent rocking
when the doors are opened and closed.
• The rollers allow you to move the refrigerator from
the wall for cleaning.
To level the refrigerator:
• Level the refrigerator by turning the roller adjust-
ment screws clockwise to raise the refrigerator,
counterclockwise to lower the refrigerator.
• Use a 3/8" hex socket, wrench or adjustable
wrench.
Roller Adjusting Screws
Rollers at the rear can also be adjusted.
• Use a 5/16" hex socket to turn the screws for the
rear rollers. Turn the screws clockwise to raise the
refrigerator, turn counterclockwise to lower it.
Installation Instructions
Rollers
STEP 7 LEVEL THE DOORS
If the doors are not evenly aligned at the top, the
refrigerator door can be adjusted.
• Use a 7/16" hex socket or wrench to turn the door
adjusting screw. Turn the screw to the right to raise
the door, turn left to lower the door.
Raise
NOTE: A nylon plug is imbedded in the threads of
the pin. The plug is designed to prevent the pin from
turning. A wrench must be used to turn the pin.
• Turn the wrench one or two times. Open and close
the refrigerator door to check alignment with the
freezer door at the top. Adjust again if necessary.
8
Doors Should
Align at Top
Raise