Step 12A, Install Overlay Panels - GE ZISS480DXBSS Installation Instructions Manual

Installation Instructions
ISTEP 12A I INSTALL OVERLAY PANELS
Install door panels:
. Open door to 90 °. Remove the 6 Phillips head screws
from the door handle,
. Remove the handle. Retain all screws.
. Remove the 6 screws holding the trim, then lift off
the trim. Retain the screws.
. Slide the overlay panel into the door trim.
Dispenser Models Only:
. The dispenser controls protrude beyond the face
of the freezer door. To avoid damage to the dispenser,
the trim at the top of the door should be removed,
. Remove the screws holding the top trim in place.
. Place the assembled freezer panel into the bottom
channel and slide into the hinge side trim,
. Reinstall the top trim piece with the screws.
. There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original screws
in the REARscrew holes,
. Secure the handle to the door using the FRONT
screw holes,
. Follow the same procedures to install the opposite panel.
. Check to be sure the handles are evenly aligned with
each other at the top. To adjust, loosen the handle
screws and slide up or down. Tighten the screws.
Handle
Trim
Move
Forward
For 3/4"
Panel
1
Door Trim
Refrigerator
Door
k\\\\\\\\\\\\\\\\\\\\\l
Supplied Handle
Shown in Overlay
Pane/Position
//
/
", _;/_ Use Front Hole:
'_. _ to Secure Handl,
- -.......... use uear HOleS
to Secure Trim
16