Step 7 Level Refrigerator - GE 42" Owner's Manual And Installation Instructions

STEP 7 LEVEL REFRIGERATOR

All models have 4-point leveling. The front is supported
by leveling legs, the rear is supported by adjustable
wheels. Both are accessible from the front of the
refrigerator.
• To level the back of the refrigerator, turn the 7/16" hex
nut located above the front
wheels. Turn clockwise to
raise or counterclockwise to
lower the refrigerator.
• For front leveling, use a
1-1/4" open-end wrench.
• Adjust height of refrigerator
to match installation cutout
opening 84-1/2". The
refrigerator should be level
and plumb with cabinetry.
NOTICE: The rear leveling wheels and front leveling
legs are limited to a maximum height adjustment of 1".
If the installation requires more than 84-1/2" height,
the installer should elevate the refrigerator on a sheet
of plywood or runners. Cabinetry trim could also be
added across the top of the opening to shorten the
opening. If you attempt to raise the refrigerator more
than 1", you will damage the front leveling legs and
the rear leveling wheels. Make adjustments in small
increments.
STEP 8 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent tipping.
• Raise the grille panel to access case trim.
• Use a 3/16" bit to drill four evenly spaced clearance
holes through the metal top case trim.
22
Installation Instructions
STEP 8 ALTERNATE ANTI-TIP
PROCEDURE (Cont.)
• Use a 1/16" bit to drill to pilot holes through the metal
clearance holes and into the wood soffit. The holes
should be centered in the soffit or a 3/4" min. wood
brace. The brace spanning the enclosure must be
securely fastened to cabinets on both sides.
• Install four, 1-1/2" drywall screws into the pilot holes.
• Drill screws into adjacent cabinets through side case
trim.
STEP 9 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to a 90°
opening. The 130°, door swing option is not to be used
for the SxS 42" and 48" models. Skip this step if door
opening is satisfactory for your installation situation.
• Open the door to view the bottom hinge.
Note the door stop pin locations. The pin is factory
installed in the 115° position.
• Close the door.
From below,
use pliers to
unscrew the
door stop
and reinstall
into the 90°
position.
WARNING
Pinch Point Hazard
Door Trim Pinch Point Hazard
ll l d f
Improper installation can lead to a finger pinch point
hazard between the side door trim and the cabinets
when operating the door, especially with children.
To minimize this risk you must follow the installation
instructions for cabinet dimensions, trim assembly,
and door stop angle.
h