Set The Required Room Temperature; Set The Heat Pump For Extra Hot Water - Worcester GREENSTORE User Manaul

Basic functions - Customer level 1

Set the required room temperature

If a room sensor is connected to the heat pump the temperature of the room
can be set using the Room temperature menu, or by using the Extra functions
menu (Customer level 2).
To set the room temperature::
1. Press the Heat button in the initial menu.
2. Turn the menu dial clockwise until the Room temperature menu is displayed.
Room temperature
10° 20,0
Return Adjust
3. Press the Adjust button.
4. Turn the menu dial clockwise to increase the room temperature. Turn the
menu dial anti-clockwise to lower the room temperature.
5. Save the new value by pressing the Save button.

Set the heat pump for extra hot water

Extra hot water can be obtained by temporarily increasing the temperature
of the water in the hot water cylinder. This may be appropriate when, for
example, a large number of people need to shower. This function may be
needed for long demands for hot water.
1. Press the Heat button in the initial menu.
2. Turn the menu dial clockwise until you reach the menu Extra hotwater.
Extra hotwater
1h 24h
Return Adjust
3. Press the Adjust button.
4. Turn the menu dial clockwise to choose the number of hours that the
electric heater should be on (e.g. 24 hours).
Extra hotwater
1h 24h
Return
5. Save the new value by pressing the Save button.
30°
48h
48h
Save
The example describes how to set the
required room temperature with the
help of a connected room sensor. The
range is 10ºC to 30ºC.
When the set time has elapsed the
setting must be repeated to get extra
hot water again.
16
Note
Note