MAINTENANCE WORK ON CHASSIS AND ENGINE
Greasing the steering head bearing
9.30
Removing the front fender
9.31
Installing the front fender
9.32
Removing the start number plate
9.33
–
Mount and tighten screw
Guideline
Screw, top steering stem
–
Check that the wiring harness, throttle cables and brake and clutch lines can move
freely and are routed correctly.
–
Check the play of the steering head bearing. (
B00019-11
x
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
–
Remove screws
–
Make sure the spacers remain in place.
500092-10
–
Ensure that the spacers are mounted in the fender.
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
Info
Make sure the holding lugs engage in the start number plate.
500092-10
–
Remove screw
–
Remove screw
500123-10
.
M8
(
p. 36)
x
x
(
p. 36)
. Remove the front fender.
M6
and take off the clamp.
. Take off the start number plate.
17 Nm
Loctite
®
243™
(12.5 lbf ft)
p. 33)
.
10 Nm (7.4 lbf ft)
37