Table of Contents
Advertisement
TROUBLESHOOTING
Faults
Engine turns but does not start
Engine has no idle
Engine does not speed up
Engine has too little power
Engine stalls or is popping into the
carburetor
Engine overheats
Possible cause
Operating error
Motorcycle was out of use for a long
time and there is old fuel in the float
chamber
Fuel feed interrupted
Engine flooded
Spark plug oily or wet
Electrode distance (plug gap) of spark
plug too wide
Fault in ignition system
Short circuit cable in cable harness
frayed, short circuit button defective
Socket connector or ignition coil is
loose or oxidized
Water in carburetor or jets blocked
Idling jet blocked
Adjusting screws on carburetor dis-
torted
Spark plug defective
Ignition system defective
Carburetor running over because float
needle dirty or worn
Loose carburetor jets
Fault in ignition system
Fuel feed interrupted
Air filter very dirty
Exhaust system leaky, deformed or
too little glass fiber yarn filling in
main silencer
Fault in ignition system
Diaphragm or reed valve housing
damaged
Lack of fuel
Engine takes in bad air
Socket connector or ignition coil is
loose or oxidized
Too little coolant in cooling system
Too little air stream
Action
–
Go through the steps of starting the engine.
(
p. 19)
–
Empty the carburetor float chamber.
(
p. 68)
–
Check the fuel tank breather.
–
Clean the fuel tap.
–
Check/set the carburetor components.
–
Clean and dry the spark plug, or change it if
necessary.
–
Clean and dry the spark plug, or change it if
necessary.
–
Adjust the plug gap.
Guideline
(125 SX, 150 SX)
Spark plug electrode gap
0.60 mm (0.0236 in)
(250 SX)
Spark plug electrode gap
0.60 mm (0.0236 in)
–
Check the ignition system.
–
Check the short circuit button.
–
Clean the plug-in connector and treat it with
contact spray.
–
Check/set the carburetor components.
–
Check/set the carburetor components.
–
Carburetor - adjust the idle speed.
(
p. 67)
–
Change the spark plug.
–
Check the ignition coil.
x
–
Check the spark plug connector.
–
Check/set the carburetor components.
–
Check/set the carburetor components.
–
Check the ignition system.
–
Check the fuel tank breather.
–
Clean the fuel tap.
–
Check/set the carburetor components.
–
Clean the air filter.
(
x
–
Check exhaust system for damage.
–
Change the glass fiber yarn filling of the main
silencer.
(
p. 61)
x
–
Check the ignition system.
–
Check the diaphragm and reed valve housing.
–
Turn handle
of the fuel tap to the ON posi-
tion. (Figure B00003-10
–
Refuel. (
p. 21)
–
Check the intake flange and carburetor for
tightness.
–
Clean the plug-in connector and treat it with
contact spray.
–
Check the cooling system for leakage.
–
Check the coolant level. (
–
Switch off engine when stationary.
72
x
x
x
x
x
x
p. 63)
x
p. 11)
p. 59)
Advertisement
Table of Contents
