KitchenAid KGRK806PBT02 Installation Instructions Manual page 10

Typical flexible connection
1. Apply pipe-joint compound made for use with LP gas to the
smaller thread ends of the flexible connector adapters (see B
and G in following illustration),
2. Attach one adapter to the gas pressure regulator and the
other adapter to the gas shutoff valve, Tighten both adapters.
3. Use a 1%6"combination wrench and channel lock pliers to
attach the flexible connector to the adapters. Check that
connector is not kinked,
A
B C
D
E
\
\
H G F
A. Gas pressure regulator
B. Use pipe-joint compound
C. Adapter (must have _/2"male
pipe thread)
D. Flexible connector
E. Manual gas shutoff valve
F. F2" or 3/4"gas pipe
G. Use pipe-joint compound
H. Adapter
Complete Connection
1. Check that the gas pressure regulator shutoff valve is in the
"on" position.
A. Gaspressure regulator shutoff valve
2. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
3.
A. Closed valve
B. Open valve
Test all connections by brushing on an approved
noncorrosive leak-detection solution. Bubbles will show a
leak, Correct any leak found.
Remove cooktop burner caps and grates from parts
package. Align notches in burner caps with pins in burner
base. Burner caps should be level when properly positioned,
If burner caps are not properly positioned, surface burners
will not light. Place burner grates over burners and caps.
A. Burner base
B. Burner cap
C. Burner grate
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord,
Failure to follow these instructions can result in death,
fire, or electrical shock.
5. Plug into a grounded 3 prong outlet.
Initial lighting and gas flame adjustments
Cooktop and oven burners use electronic igniters in place of
standing pilots. When the cooktop control knob is turned to the
"LITE" position, the system creates a spark to light the burner.
This sparking continues, as long as the control knob is turned to
"LITE,"
When the oven control is turned to the desired setting, sparking
occurs and ignites the gas,
10