Kenmore 25370229001 Installation Instructions Manual page 4

Place Cabinet in
Window
1. Open window and mark
center of window stool.
,
Install Support
;racket
Hold each support bracket flush against
outside of sill, and tight to bottom of cabinet
as shown below. Mark brackets at top level of
sill, and remove.
.
Place cabinet in window with bottom stool
angle firmly seated over window stool as
shown. Bring window down temporarily
behind top angle to hold cabinet in place.
STOOL /
_STOOL
3. Shift cabinet left or right as needed to line up
center of cabinet on center line marked on
stool.
4. Fasten cabinet to window stool with 2 screws
into holes. (You may wish to pre-drill pilot
boles.)
5. Add bottom rail seal over screws to window
stool.
3/4" LONG HEX-
HEAD SCREW
4
1/2" LONG SCREWS
LEFT
\ LOCKNUTS
t
SILL ANGLE
FLAT HEAD BOLT
IHT
2 EACH REQ'D FOR EACH
SUPPORT BRACKET
2. Assemble sill angle bracket to support brackets
at the marked position, as shown. Hand
tighten, but allow for any changes later.
3. Install support brackets (with sill
ngle
brackets attached) to correct hole in bottom
of cabinet as shown.
4. Tighten all 6 bolts securely.
1/2" long screws
and Iocknuts