Binding And Rf Test; Heat Demand; Zone Binding; Outdoor Sensor - Honeywell EVOTOUCH CONTROLLER Installation Manual

Binding and RF Test

Allows you to bind or test sensors or actuators throughout the
system:
Binding will normally be performed with evotouch positioned
beside the actuator or sensor, for convenience.
RF Test is then used to check the communication performance
of all devices in their correct locations.

Heat Demand

Binds to the heat demand device:

Zone Binding

You are first prompted to specify the zone to bind:
You will then be prompted to bind one representative sensor and
one or more actuators to the selected zone.

Outdoor Sensor

Binds to the outdoor sensor:

RF Test Heat Demand

Tests the boiler heat demand:

RF Test Zones

You are first prompted to specify the zone to test:
You will then be prompted to perform an RF test to the selected
zone.

RF Test Outdoor

Tests RF communication with the outdoor sensor.
9