Installation Location; Installation Room; Installation Cavity; Furniture/Fixtures - Thermador T36IT70NNP/04 Installation Instructions Manual

installation location
Do not install the appliance:
outdoors,
in an environment with dripping water,
in rooms which are at risk of frost.
Appliance is very heaw for empty weight see the
following table:
BM (Bottom Mount) 36" approx. 430 tbs / 195 kg
Installation room
The appliance should be installed in a dry, ventilated
room.
The ambient temperature should not drop below 55 °F
(13 °C) or rise above 110 °F (43 °C), otherwise
malfunctions may occur.
The installation location should not be exposed to direct
sunlight and not placed near a heat source, such as an
oven, radiator, etc. If installation next to a heat source is
unavoidable, use a suitable insulating plate or observe
the following minimum distances from the heat source:
11/4" (30 mm) from an electric cooker,
12" (300 mm) from an oil or solid fuel cooker.
Installation cavity
It is important to observe the specified dimensions of
the installation cavity for a trouble free installation of the
appliance and for the subsequent general view of the
furniture front.
[_ln particular ensure that the cavity is square.
Squareness can be checked by suitable means,
e.g. spirit level, diagonal measurements, etc.
[_The side walls of the cavity must be flush.
The minimum thickness of side walls and the top watt
must be 5/8" (16 mm).
The minimum thickness of toe kick panet must be
U2" (13 mm).
A thickness of s/4"(19 mm) is recommended.
Furniture/fixtures
The new appliance is screwed securely to adjacent
and overhead furniture/fixtures.
For this reason it is essential that all attachable
furniture/fixtures are connected securely to the
base or the watt by suitable means.
Base
A fully toad appliance is very heavy for the
toad bearing capacity at least see the following table:
BM (Bottom Mount) 36" approx. 1200 tbs / 540 kg
To ensure that the appliance is installed securely and
functions properly, the base must be flat and level.
The base must be made of a hard, rigid material.
The installation area must be the same height as the rest
of the room.
On account of the heaw weight of a fully loaded
appliance, a toad bearing base is required. If in doubt,
contact an architect or a building expert.
6