Installation - Hoover HDO 7251 X User Instructions

INSTALLATION

Installing a domestic appliance can be a complicated operation which, if not carried
out correctly, can seriously affect consumer safety.
It is for this reason that the task should be undertaken by a professionally qualified
person who will carry it out in accordance with the technical regulations in force.
In the event that this advice is ignored and the installation is carried out by an un
qualified person, the manufacturer declines all responsibility for any technical failure
of the product whether or not it results in damage to goods or inyury to individuals.
Installation is the customer's responsibility. The manufacturer has no obligation to carry this
out. If the assistance of the manufacturer is required to rectify faults arising from incorrect
installation, this assistance is not covered by the guarantee.
The installation instructions for professionally qualified personnel must be followed. Incorrect
installation may cause harm or injury to people, animals or things. The manufacturer cannot
be held responsible for such harm or injury.
FITTING THE OVEN INTO THE KITCHEN UNIT
Fit the oven into the space provided in the kitchen unit: it may be fitted underneath a work
top or into an upright cupboard.
Fix the oven in position by screwing into place, using the four fixing holes in the frame.
To locate the fixing holes, open the oven door and look inside.
To allow adequate ventilation, the measurements and distances indicated in the diagram on
page 21 be adhered to when fitting the oven.
IMPORTANT
If the oven is to work properly, the kitchen housing must be suitable.
The panels of the kitchen unit that are next to the oven must be made of a heat resistant
material. Ensure that the glues of units made of veneered wood can withstand temperatures
of at least 120 °C. Plastics or glues that cannot withstand such temperatures will melt and
deform the unit. Once the oven has been lodged inside the unit, the electrical parts must be
completely insulated. This is a legal safety requirement. All guards must be firmly fixed into
place so that it impossible to remove them without using special tools.
Remove the back of the kitchen unit to ensure an adequate current of air circulates
around the oven.
INSTALLATION: "ELECTRICAL CONNECTION"
The mains electricity supply connected to the appliance should comply with the norms in
force in the country of installation.
The manufacturer declines all responsibility for any damage that may be caused by
unsuitable or unreasonable use.
Warning:
• Always check before any electrical operation, the supply voltage shown on the electricity
meter, the adjustment of the circuit-breaker, the continuity of the connection to earth of the
installation and that the fuse is suitable.