Placing The Grade Crossing With Flashers On Your Layout - Lionel FasTrack Grade Crossing with Flashers Owner's Manual

Placing the Grade Crossing with Flashers on your layout

C
hoose a location on your layout for the grade crossing. When you assemble the track
sections, be sure that the "broken" rails on the Isolated Track sections (included) are
on the same side (i.e., locate both "breaks" inside the track loop or outside the track loop).
Be sure that the switch on the grade crossing is located on the same side as the breaks in the
Isolated Track sections. Refer to Figure 1.
Note!
The breaks must be located on the same side of the track.
If you would like your trains to activate the accessory earlier or to prolong the operation
of the accessory, you may choose to purchase Insulated Track sections (6-12027). Be sure that
the Insulated Track sections are next to the grade crossing and between the Isolated Track
sections (included).
Place only Insulated Track sections (available separately, 6-12027) and the grade
Note!
crossing between the Isolated Track sections (included).
Isolated Track
Break
Figure 1. Grade Crossing location
Grade Crossing
Section
Switch
3
Isolated Track
Section
Break