Lp Gas Conversion - Whirlpool YSF379LEKQ0 Installation Instructions Manual

3-Check
the broil burner for proper
flame.The flame should be 1/2" (13 mm) long,
with inner cone of bluish-green, and outer
mantle of clark blue, and should be clean and
soft in character. No yellow tips, blowing or
lifting of flame should occur.
If flame needs to be adjusted:
Loosen the lock screw on the air shutter located at the
rear of the broil burner. Adjust the air shutter as needed.
Tighten lock screw.
[]Turn the oven control knob to "OFF" or press
the "OFF/CANCEl" pad.
You have just finished installing
your new range.To get the most efficient use
from your range, read your Use & Care Guide.
Keep Installation Instructions and Guide close
to range for easy reference.
The instructions will make installing the range
in another home as easy as the first
installation.
Gas conversions (from Natural gas to L.P.gas; or from L.P.
gas to Natural gas) must be done by a qualified installer.
L.P.gas conversion
[] Complete installation sections A-C (Pages 7-8)
before converting cooktop to L.P.gas. Check that main gas
supply line has been shut off and the power supply cord is
disconnected.
regulatorpressure .......
/pressure __
plastic cover plastic cover L.R
_- cap
--washer --
Nat. gas L.P, gas
DO NOT REIVIOVETHEPRESSUREREGULATOR.
[] Pressure regulator: Remove storage drawer and locate
pressure regulator at back of range. Remove plastic cover.
Turn cap marked "N" on front of pressure regulator counter-
clockwise with a wrench to remove. Do Not disturb or
remove the spring beneath the cap.Turn the cap over and
reinstall cap on regulator so that the letters "L.R" are visible.
Replace plastic cover over cap.
orifice
[] Surface Burners: spud
Remove burner caps. Use
orifice
a Phillips or Quadrex spud
screwdriver to remove holder\
the two screws holding the
burner head down. Lift the
burner head off the cooktop
to uncover the orifice spud
_ einstall
one of the
screws
spark electrode
range cooktop
holder.The orifice spud is recessed in the holder.
Note: Reinstall one of the screws through the range cooktop
to hold orifice spud holder in place while removing and
replacing orifice spuds.
Page 13