Advertisement
\_J
range feet
m Making sure the anti=tip bracket is
installed:
, Look for the anti-tip bracket secureUy
attached to floor.
, SUiderange back so rear range foot is
under anti-tip bracket.
Rfinstalling the range in a mobile
home, you MUST secure the range to the
floor. Any method of securing the range
is adequate as long as it conforms to the
"Manufactured
Home Construction and
Safety Standard/' Page 2.
Place rack in oven. Place level on
rack, first side to side; then front to back.
if range is not level, pull range forward
until rear leveling leg is removed from
the anti-tip bracket. Use 3/8" drive ratchet
and channel lock pliers to adjust leveling
legs up or down until range is level. Push
range back into position. Check that rear
leveling leg is engaged in anti-tip bracket.
Note: Oven must be level for satisfactory
baking conditions.
Gas and electrical
AH connections
must be wrench=tightened.
Typical
flexible
connection
pressure
regu_ater
connection
fitting
adapter
_peund
manua_
1/2" to 3/4"
gas pipe_
A 1/2"
mate pipe thread
is needed
for connection
to
pressure
regulater
female
pipe threads,
l
m if a flexible appliance connector
is used, be certain connector is not
kinked.
3m
Check that range regulator
shutoff valve is in the "on" position.
Open
the manual shutoff valve in the gas
Test all connections
by
brushing
on an approved
non-corrosive
leak-detection
solution.
Bubbles will show
a leak. If a leak appears, shut off gas
supply valve and tighten
connections.
Then check connections
again. Never test
for gas _eaks with
a match or other
flame. Clean all leak-detection
solution
from gas connections.
Close broiler
door.
5u
Place burners, burner caps and
grates on cooktop.
6m
Plug power supply cord into
grounded electrical outlet.
Assemble the flexible
connector to the gas supply pipe to the
pressure regulator connection fitting,
using the adapter fittings provided with
the flexible connector. Use pipe-joint
compound made for use with L.R gas to
seal all pipe thread connections.
m Check that ail control knobs
are in the "OFF" position.
Check operation
Electronic
ignition system
Cooktop and oven burners use electronic
ignitors in place of standing pilots. When
a cooktop control knob is turned to the
"LFE" position, the system creates a
spark to light the burner.This sparking
continues until the control knob is turned
to the desired setting.
When the oven control is turned to the
desired setting, a hot surface ignitor
heats to a bright orange and ignites the
gas. No sparking occurs.The glow bar
remains on while
the burner operates.
Advertisement
