Anti-Tip Bracket - Whirlpool SF315PEMT1 Installation Instructions Manual

Parts suppJied for
2 screws (#18 x 1=1/2")
(Bracket must be securely mounted to
sub4toor. Thickness of flooring may require
longer screws to anchor the bracket to
subfioor.)
Proper gas supply
connection must be
available. See "Gas
Page 4.
Grounded electriea_
outJet is required.
See "EUectdcaU
requirements;'
Page 4.
24=1/4"
_6 _R
cooktop
height
This shaded area
tecoraraended for
e_ectricaJ out_et.
i
i
i
i
space to side wall or
other corabustibJe
raatedal
This shaded area
for installation
of gas pipe,
Contact a qualified
Roar covering
installer to check
that the Hoot
covering can
withstand at least
200°E
Use an insulated
pad or 1/4" pJywood
under range if
instaEling range over
carpeting.
Check location where range will be installed. The
range should be _ocated for convenient use in the
kitchen. Recessed installations faust provide
coraplete enclosure of the sides and rear of range.
ALL OPENBNGS IN THE WALL OR FLOOR WHERE
RANGE ISTO BE INSTALLED MUST BE SEALED.
iMPORTANT: Some cabinet and building raaterials are
not designed to withstand the heat produced by the
oven for baking and self=cleaning. Check with your
builder or cabinet supplier to make sure that the
raatetials used will not discolor, delarainate or sustain
other daraage.
*** Note: 24" rain. when bottom of wood or metal
cabinet is protected by not less than 1/4"
Rarae retardant raillboard covered with not
less than No. 28 MSG sheet steel, 0.015"
stainJess steel, 0.024" aJurainura or 0.020"
copper,
30" rain. cJeatance between the top of the
cooking pJatforra and the bottom of an
unprotected wood or metal cabinet.
Do Not seal the range to
the side cabinets.
Jf cabinet depth is greater
than 24", oven frame
must extend beyond
cabinet fronts by 1/2"
rain.
Anti-tip bracket:
The floor anti-tip
bracket MUST be
installed. To install
antFtip bracket
shipped with the
range, see Page 7
and the anti-tip
bracket template.
I8" rain.
c_earance
upper
cabinet to
countertop