Table of Contents
Advertisement
J39/J40/J45/J46: SATA2.0 Connector
7
1
J52: BIOS Recovery Mode Jumper
J42: Clear CMOS Jumper
Normal (Default)
Clear CMOS
1
GND
2
SATA TX DP
3
SATA TX DN
4
GND
5
SATA RX DN
6
SATA RX DP
7
GND
Pin 1-2 Closed: Normal
Pin 2-3 Closed: BIOS Recovery
You can reset the CMOS settings by using this jumper. This
can be useful if you have forgotten your system/setup
password, or need to clear the system BIOS setting.
1. Power off system and disconnect power connectors from
the motherboard.
2. Remove the jumper from Pin_1 and Pin_2 (Default setting).
3. Move the jumper cap to close Pin_2 and Pin_3 for several
seconds to Clear CMOS.
4. Put jumper cap back to Pin_1 and Pin_2 (Default setting).
5. Reconnect power connectors to the motherboard and
power on system.
http://www.tyan.com
Connects to the Serial ATA ready
drives via the Serial ATA cable.
J39: SATA2
J45: SATA3
(Default)
20
J40: SATA4
J46: SATA5
Advertisement
Table of Contents
