Maintenance; Routine Maintenance; Walking Belt And Deck Lubrication - Bowflex TreadClimber 1000 Owner's Manual

The safety and integrity designed into a machine can only be maintained when the equipment is regularly
examined for damage and repaired. It is the sole responsibility of the owner to ensure that regular maintenance is
performed. The owner is responsible to make sure that regular maintenance is done. Worn or damaged
components must be repaired or replaced immediately. Only manufacturer supplied components should be used to
maintain/repair the equipment.
This product, its packaging, and components contain chemicals known to the State of California to cause cancer,
birth defects, or reproductive harm. This Notice is provided in accordance with California's Proposition 65. If you
would like additional information, please refer to our website at www.nautilus.com/prop65.
Always unplug your TreadClimber
the unit. To prevent unsupervised operation of the machine always remove the Safety Key and disconnect the
power cord from the wall outlet or machine AC inlet.

Routine Maintenance

For general routine maintenance and cleaning see the Care of the Machine section of this manual.

Walking Belt and Deck Lubrication

The TreadClimber machine is equipped with a pre-lubricated, low maintenance deck and belt system. Belt friction may
®
affect the function and life of the TreadClimber
treadles periodically with a silicone lubricant, using the following instructions:
1. Unplug the TreadClimber
W A R N I N G
power plug.
D A N G E R
A T T E N T I O N
2. While the TreadClimber
lubricant directly onto the treadle beneath each belt. Gently lift each side of the belt and apply a few drops of the
lubricant.
IMMEDIATE ACTION REQUIRED
Always use a silicone-based lubricant. Never use a de greaser like WD-40
C A U T I O N
exercise machine as this could seriously impact performance.
3. Plug the TreadClimber
4. Stand to one side of your TreadClimber
5. Turn on your TreadClimber
seconds.
6. Turn off your TreadClimber
7. Take care to wipe up any excess lubricant from the treadles and and surrounding floor. We also recommend a
periodic inspection of the treadle surfaces under the belts. If the decks appear worn, contact contact Nautilus
Customer Service.
To reduce the possibility of slipping, be sure the treadle area is free from grease or oil. Wipe off any excess oil
from the machine surfaces.
Use the following timetable as a guide to lubricate the decks:

Maintenance

machine from the outlet and let sit for 5 minutes before cleaning or servicing
®
machine. For the best results from the TreadClimber
®
machine completely from the wall outlet, and remove the power cord from the incoming
®
Always unplug the power cord from the wall outlet and wait 5 minutes after unplugging the
machine before removing or installing parts to avoid the risk of electrocution, shock or
mechanical injury.
machine's treadle surfaces are still warm (not hot), apply a very thin layer of silicone
®
machine back into the machine base and then into the wall outlet.
®
machine.
®
, and start the belts at the slowest speed. Let the belts run for approximately 15
®
machine.
®
machine, lubricate the
®
on the Bowflex TreadClimber
® ®
Owner's Manual
®
®
25