Electrolux E48DF76EPS Installation Instructions Manual page 34

[] Electrolux I nc o N
10-1
10-2
10-3
Make sure that all knobs on the front of the 10-4
range are in the off position.
With electrical power to the range disconnected.,
open the LPG supply valve.
Using a gas leak detector or bubble forming leak 10-5
detection fluid, check the following for leaks:
10-6
• LPG gas supply connection
• All manifold connections
• All valve connections
• Bypass orifices
Re-assemble the burner heads, burner head
nuts, burner rings, and burner caps without the
spill tray in place. Be sure the igniter wire is
connected to each burner head.
Connect the range to the electrical outlet.
Turn each burner on HIGH, one at a time.
Check for leaks around the valves (including the
bypass orifice) and the burner lines.
Igniter
Connect igniter wire here /
J \
Burner Head
Fiqure 10-1 Iqniter Connection
[-'Jl/_l_ ill _ _
11-1 Turn each burner on HIGH and then off again,
several times. If the flame does not light
repeatedly and rapidly, check for obstructions
between the igniter and the burner head (see
Figure 10-1).
11-2 Make sure that the flame:
• Is stable.
• Does not waver or lift up from the burner.
• Is predominatety blue in color.
• Is not predominatety yellow at the tips.
If the flame does not have the correct appearance, check the shutter gap settings (see STEP 9). If adjusting the
air shutters will not correct the problem, contact the factory.
Fiqure 11-1 Examples of a Normal Flame
Page 10