Electrolux E48DF76EPS Installation Instructions Manual page 30

[] Electrolux [ Ic o N
6-1 Make sure all knobs are in the off position,
6-2 Remove all of the burner knobs from the front of
the range,
6-3 Insert the 1/8" screwdriver into the valve stem
hole for the left rear burner, Unscrew the bypass
orifice from the right side of the valve assembly.
6-4 Identify the appropriate bypass orifice from
Table 6-1. Match both the model number and
the burner location, The bypass orifice size is
stamped on its head,
6-5 Insert the bypass orifice and the attached o-ring
into the right side of the valve with the needle
nose pliers. Tighten into place with the 1/8"
screwdriver.
6-6 Repeat steps 6-1 through 6-5 for the remaining
burner valves,
6-7 Replace the knobs.
Burner E30DF74EPS E36DF76EPS E48DF76EPS
Location (30-Inch) (36-Inch) (48-Inch)
Left: Rear 61 61 61
Left Front 48 48 48
Right Rear 61 48 48
Ric)ht Front 61 61 61
Center Rear 61 61
Center Front 61 61
Table B-1 Bypass Orifice Sizes (x 100 rnrn}
Valve Stem
Fiqure 6-1 Bypass Orifice Conversion
Page 6