Electrolux E48DF76EPS Installation Instructions Manual page 28

[] Electrolux [ i c o N
1-'II / :1_ 1 U i_ ,B1 i_l _.1 i[, [=i [,] ile[,] itVL_i_-1 [,] i
3-1 Move the range out from the wail, if necessary.
3-2 If the range is connected to a natural gas supply
line, close the gas supply valve.
3-3 Disconnect the range power connector from the
electrical outlet.
3-4 Remove the grates from the cooktop.
3-5 Remove all of the burner caps and burner rings
from top of the burner heads.
Burner Cap
Burner
Burner Head-
Fiqure 3-1 Grate, Burner Cap and Burner Rinq Removal
4-1 Locate and remove the regulator access panel
on the back of the range.
4-2 Locate the regulator and remove the regulator
cap. Make sure that the regulator spring remains
in place.
4-3 Remove the spool from the cap and insert the
opposite side. The large end of the spool must
insert into the regulator first for LPG operation.
4-4 Replace the cap. The access panel will be re-
installed later.
Regulator Spring
Spool: Direction
for LPG XXX
Regulat°r Cap X4@ _'X
Spool: Direction
for natural gas
Fiqure 4-1
Access panel for
E36DF76EPS &
E48DF76EPS
Access panel for-_D
E30DF74EPS
Requlator Conversion
..... -j
°- .... °
r.
o
Back of range
Page 4