Electrolux E48DF76EPS Installation Instructions Manual page 17

NSTALUN@ THE
38 & 48
NGE
©PT @NAL
BACKGUARDS
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Your Etectrolux Icon
TM
range was shipped with a backguard inplace.These
instructions cover the installation of one of the optional backguards.
mnstaHing the Range Optiona_ Backguard:
1. Remove the backguard from its box.
2. To avoid scratches, place small scraps of thin cardboard on the rear of
the side panels where the backguard will make contact. With the
assistance of at least one other person, carefully lift the backguard and
place down on to the range top. Special attention should be given to the .....
lower flange in front of the backguard, which must fit between the
stainless steel side panels.
3. Fasten the provided screws through the rear flange.
4. Connect the gas line to the regulator. Reposition and attach the access
panel or the back cover if the entire back cover was removed.
5. You are now ready to continue with the range installation.
Figure 11
BackguarU
Backguard Installation
(36" range shown)
Figure 12
Backguard Installation
(48" range shown)