Electrolux E48DF76EPS Installation Instructions Manual page 31

Professional Series Range LPG Conversion Kit
7-1 Remove the two screws that hold the left rear
burner base to the stove chassis.
7-2 Hold the shutter connector with the 8"
adjustable wrench. Remove the air shutter using
the 6" adjustable wrench.
7-3 Hold the shutter connector with the 8"
adjustable wrench. Remove the main orifice
from the shutter connector using the 10 mm
open-end wrench.
7-4 Replace the main orifice with the appropriate
size from Table 7-1, Match both the model
number and the burner location. The main
orifice size is stamped on its side, The shutter
and the burner base will be re-assembled after
pressure testing,
7-5 Check to make sure that the compression nut is
tightened into the back of the shutter connector.
7-6 Repeat steps 7-1 through 7-5 for the remaining
burners.
Burner E30DF74EPS E36DF76EPS E4BDF76EPS
Location _30-Inch) _36-Inch) _48-Inch)
Left Rear 84 112 112
Left Front 111 86 86
Right Rear 111 86 86
Ricjht Front 118 112 112
Center Rear 118 118
Center Front 118 118
Table 7-1 Main Orifice Sizes (X 100 mrn)
Compression Nut
Main Orifice
t
Shutter Connector
Air Shutter (remove)
Burner Base
\
Fiqure 7-1 Main Orifice Conversion
Page 7