Table of Contents
Advertisement
(Fig. 6-6)
(Fig. 6-7)
6.4
Adjusting the antenna
In order to turn the antenna to its optimal position, your recei-
ver is equipped with a signal strength indicator.
>
Use the Menu key to display the Main Menu
>
Now select the menu line Settings.
>
Confirm by pressing OK.
>
The sub-menu Settings will be displayed (Fig. 6-6).
>
Now use the arrow keys up/down to mark the menu
line Adjust antenna.
>
Confirm by pressing OK. The menu Adjust antenna
will be displayed (Fig. 6-7).
>
Now use the arrow keys left/right to enter the chan-
nel with the weakest reception signal.
>
Now adjust and position the antenna so that both bar
graphs show a maximum value.
Red bar
poor reception
Yellow bar
good reception
Green bar
very good reception
7 Operation
7.1 Switching on and off
>
Switch the digital receiver on by pressing the
On/Standby key either on the unit or on the remote
control.
>
Press the same key again, either on the unit or on the
remote control, to switch the receiver off.
>
The receiver is now in standby mode. If this feature
has been activated (as described in Point 6.2.4) the
current time will be shown in the display.
If the current time is not shown, this must still be
downloaded to the receiver. To do this, switch the unit
on and switch to reception of a major channel, such as
ZDF, that broadcasts a time signal, for about 30
seconds, to acquire the current time automatically.
7.2 Programme selection
7.2.1 Using the programme up/down keys
>
Use the programme up/down keys either on the unit
or on the remote control to move up or down by one
programme slot at a time.
7.2.2 Using the numeric keys
>
Use the numeric keys to enter the desired program-
me number.
For example:
1
1,
then 4
2,
then 3,
When entering programme numbers of more than one digit,
18
for programme slot 1
for programme slot 14
then 4 for programme slot 234
Advertisement
Table of Contents
