Numark MIXDECX QUARD Quick Start Manual page 14

Tips For Using USB Devices With Your MIXDECK QUAD
•
When disconnecting a USB device from the MIXDECK QUAD, always make sure to use the SOURCE button to switch
to CD/MP3 Mode before disconnecting. Make sure that the letters "HD" are not blinking on the display when
disconnecting a USB device.
•
Disconnecting a USB device while the MIXDECK QUAD is in USB MASTER Mode could possibly cause data on the
USB device to become corrupted and unreadable.
•
Note: There is a limit of 999 songs per folder or playlist. Use multiple folders or playlists to separate large numbers of
songs.
• We do not recommend using MP3 files over 300MB as this may affect the performance of the MIXDECK QUAD.
•
For large capacity HD, the MIXDECK QUAD can read a maximum of 9 disc partitions. Each partition is limited to 999
folders, and each folder is limited to 999 songs.
USB MIDI MODE
You can also connect the MIXDECK QUAD to a computer via USB to use
the MIXDECK QUAD's CD decks as controllers for software programs that
are compliant with USB MIDI protocol. Check with your software
manufacturer to find out if your software supports a USB MIDI controller.
To activate USB MIDI mode, connect a USB cable from the MIXDECK QUAD USB SLAVE connector to a USB port on your
computer. Then press SOURCE and turn the parameter knob to select "USB-MIDI."
MIXDECK QUAD FIRMWARE / SOFTWARE
MIXDECK QUAD works best with the latest firmware and software installed. We strongly recommend that you check for
updates right away, and continue to check regularly so you don't miss out on any of the good stuff! Visit www.numark.com for
the latest updates.
Note: Before connecting MIXDECK QUAD
to your computer, insert the included CD into
your computer to install the necessary
drivers.
14