Temperature Setting - Takagi T-M1 Installation Manual And Owner's Manual

Household Flow Rates
Appliance / Use
Lavatory Faucet
Bath Tub
Shower
Kitchen Sink
Dishwasher
Washing Machine
Taken from UPC 1997
WARNING
Hot Water Heater temperatures over
125°F can cause severe burns instantly or
death from scalding. The outlet hot water
temperature of the MOBIUS T-M1 water
heater is factory set at 122°F. Feel the
water temperature before bathing or
showering. Do not leave children, the
disabled or the elderly unattended as they
are at the highest risk of being scalded.
Temperature limiting valves are available,
ask professional person.
Only change black switches. Do not adjust any another switches
Flow Rate
(GPM)
1.0
4.0
2.0
1.5
1.5
2.0

Temperature Setting

TEMPERATURE SETTINGS
There are 4 preset temperatures that you can
select from by adjusting the dipswitch settings
on the computer board. The temperature has
been preset at the factory to122ºF (50ºC). The
computer will
temperature. At a fixture, mix cold water with
hot to get the water temperature you desire. If
you desire a hot water temperature other than
the 4 preset settings, please purchase the
optional temperature remote controller (part
No. TM-RE10). With this optional TM-RE10
you can set the temperature from 99ºF to
182ºF. Please carefully read the instructions
prior to installing the TM-RE10 as failure to do
so could damage the temperature controller
and/or the water heater, which will void the
warranty.
Hot Water Output Temperature Setting:
With the MOBIUS T-M1 Water Heater, the
output hot water temperature can be adjusted
either manually from the main computer
board's dipswitches or with the optional remote
controller (Part TM-RE10, from 99°F to 182°F).
The dipswitches can set four hot water output
temperatures 113°F, 122°F, 140°F, and 182°F
(the factory set temperature is 122°F). could
damage the temperature controller and/or the
water heater, which will void the warranty.
- 14 -
electronically control this