Installation; General; Accessories; Outdoor Installation - Takagi T-M1 Installation Manual And Owner's Manual

INSTALLATION

GENERAL

All gas water heaters require careful and
correct installation to ensure safe and efficient
operation. This manual must be followed
exactly. Read the "For Your Safety" section at
the beginning of this manual.
1. The gas regulator is preset at the
factory; it is computer controlled and
should not need adjustment;
2. Maintain proper space for servicing.
Install the unit so that it can be
connected or removed easily;
3. The electrical connection requires a
means for switching off the power
supply;
4. If you will be installing the unit in a
contaminated area with a high level of
dust, sand, flour, aerosols or other
contaminants,
airborne and enter and buildup within
the fan and burner causing damage to
the unit. The warranty will not cover
damage caused to the unit due to
installation
environment that has not be converted.
5. Particles from these objects may clog
the air vent or reduce the functions of
the rotating fan and cause improper
burning of
maintenance is recommended for these
types of environment.
6. Do not install the unit where the
exhaust vent is pointing into any
opening in a building or where the
noise may disturb your neighbors.
Make sure the vent termination is 4 feet
from a doorway or opening to prevent
exhaust from entering.
7. Some chemicals used in a beauty salon
may affect the flame sensor. Water
heater may not work properly. Please
consult with Takagi, when the water
heater is installed in a beauty salon.
8. Water hardness may affect the water
heater. Water heater may be damaged.
The warranty will not cover damage
caused by water quality.
they can become
in a contaminated
the gas. Regular
Check that the
extension cable and the warranty card were
included with the unit.

OUTDOOR INSTALLATION

Follow all local codes, or in the absence of
local codes, follow the most recent edition of
the National
Z223.1/NFPZ 54 in the USA or the CAN/CSA
B149.1 Natural gas and Propane installation
Code in Canada.
The outdoor vent cap must be used when unit
is installed outdoor. Takagi recommends the
use of its part No. TK-TV06.
When installed outdoors, the T-M1 water
heater shall be wall mounted only. Locate the
water heater in an open, unroofed area and
maintain the following minimum clearances:
Outdoor Installation Service Clearances
Piping side (Bottom)
Front (Maintenance space)
Back of heater
Top of heater
Side of heater
- 5 -

Accessories

installation manual,
Fuel Gas Code
12"
24"
1"
36"
2"
the
ANSI