Specifications And Dimensions - Empire Heating Systems PVS18(N,P)-1 Owner's Manual And Installation Instructions

Models
Maximum Input BTU/HR (KW/H)*
Minimum Input BTU/HR (KW/H)*
Height
Width
Depth with Shroud**
Gas Inlet (Pipe)
Electrical - The wall furnace comes equipped with a 5 foot (1.5m) 3 pronged cord exiting the rear left side of the wall furnace, for con-
nection to an approved 115 VAC, 60 Hz, 15A (maximum) wall receptacle.
Vent Pipe: 1-1/2 or 2 inch diameter pipe, 50 feet maximum equivalent length. See pages 25 and 28 to 31. The vent termination elbow
does not contribute to the overall vent length measurement.
* Input ratings are based on sea level operation and may vary at different elevations. No orifice change is required. The appliance will
de-rate automatically 1.5% per 1,000 feet.
** Add 3-3/8 inches for deep shroud.
All vent and combustion air pipes and fittings must be Schedule 40 PVC and meet the ANSI/ASTM Standard D1785. Cement must
conform to ASTM Standard D2564. Empire-approved poly pipe with gasketed joints may also be used. Contact your Empire dealer for
availability.
Listed for Category IV venting.
Approved Alternate Vent Systems
Manufacturer Vent System
Duravent PolyPro
Cetrotherm InnoFlue
Page 16
INTRODUCTION

SPECIFICATIONS AND DIMENSIONS

SPECIFICATIONS
Dimensions - Figure 22
PVS18(N,P)
17,500 (5.13)
8,750 (2.56)
27-7/8"
36-1/8"
13
3/8" Pipe
PVS35(N,P)
35,000 (10.26)
17,500 (5.13)
27-7/8"
36-1/8"
13
3/8" Pipe
32084-1-0713