Operating Instructions; Connecting Power; Battery Backup - Electrohome EAAC302 User Manual

CONNECTING POWER

The 1.8" Jumbo Alarm Clock Radio is equipped with an "AuTO TIME SET" feature. When
power is connected, the clock display will flash '2' which is TIME zONE 2 (Eastern time) and
the default TIME zONE setting. The correct time will be displayed, unless you are in another
time zone.
To select TIME zONE 2 (Eastern time) as your default time zone:
• Press ONCE to confirm your selection.
To change your time zone upon setup:
• Press
display; press
To change your time zone after setup:
• Press and hold the SNOOZE/SLEEP/DIM button until numbers flash.
• Press
display; press
There are 8 programmed times zones:
zone 0 - Newfoundland time
zone 1 - Atlantic time
zone 2 - Eastern time (default)

BATTERY BACKUP

This alarm clock is equipped with a battery backup feature. This feature will restore your
alarm clock settings in the event of a power outage. The 3v, CR2032 Flat Lithium battery is
pre-installed at the factory, however, should you need to replace the battery, please read
the following instructions.
ATTENTION
• When replacing the battery, do not disconnect AC plug from AC outlet. Otherwise, current time and alarm will be initialized.
• do not plug or unplug the power cable if you have wet hands.
• If you are not planning to use the unit for an extended period of time, disconnect the power cable from the wall outlet.
• Do not pull on the cord! you may damage the power cord and may cause an electric shock when disconnecting the
power cord from the wall outlet. Pull firmly at the base of the plug.

OPERATING INSTRUCTIONS

or DST/HA-°C °F
ONCE to confirm your selection.
or DST/HA-°C °F
ONCE to confirm your selection.
zone 3 - Central time
zone 4 - Mountain time
zone 5 - Pacific time
until your own time zone appears on the
until your own time zone appears on the
- 11 -
zone 6 - yukon time
zone 7 - Hawaiian time