Electrohome EAAC200 Quick Start Manual

Electrohome
Digital AM/PM clock Radio with Dual Alarm (EAAC200/EAAC201)

Power Connection

1. Plug the AC power cord into an AC outlet.
2. Clock display will flash 12:00 until set to
correct time.

Battery Backup

This alarm clock is equipped with an optional
battery backup feature. This will restore your
alarm clock settings in the event of a power
outage. Install the batteries (not included):
1. Open the battery compartment on the
bottom of the alarm clock by pushing on the
latch and pulling the door open.
2. Install 2 x AA batteries ensuring that the
battery polarity corresponds to the polarity
in the battery compartment.
3. Close the battery compartment cover.
Note:
• Batteries must be installed by an adult.
• Use only the recommended size and type of
battery specified.
• Please be sure to follow the correct polarity
when installing the battery in the battery
compartment. Reversed battery may cause
damage to the alarm clock.
• DO NOT mix different types of batteries or
mix new and used batteries.
• When not using the unit for a prolonged
period of time, please remove the batteries to
avoid possible damage caused by leaking
batteries.

Setting the Time

1. Press and hold the SET button, the time will
start to flash.
2. Press the HR button to increase the HOUR.
3. Press the MIN button to increase the
MINUTES.
4. Once time is set correctly, press the SET
button.
1