Advertisement
Available languages
Available languages
Reversing
Door
9
Preparing
to reverse door swing
1 Be sure you have adequate swing area before reversing door.
2 You will need a screw driver with a #2 square bit.
3
Protect flat work surface, such as top of dryer or floor near dryer,
with a soft cloth or towel.
4
Be sure dryer is unplugged from power source!
WARNING
Tools needed:
Screwdrivers with
#2 square &
straight bit
ELECTRICAL
SHOCK
HAZARD
Failure to disconnect
power source before servicing
could result in personal injury or even death.
Removing door and hardware
A) Removing
Trim Ring
1 Open door to 90 degree angle.
2
Remove and save trim plug and long,
course-thread,
panhead screw.
3
4
Close door.
Rotate door trim approximately
3A"counter-
clockwise and pull ring away from door.
B) Removing
Door from Hinge
1 Reopen door to 90 degree angle.
2 Remove 4 tong, course-thread,
counter-sunk
hinge screws from door.
While supporting the weight of the door
with both hands separate the door from the
hinge.
\
\
\
4 Gently place door face down on flat, covered
work surface.
Advertisement
