Advertisement
Available languages
Available languages
installation
instructions
5
Water connection
(Steam Model
on y}
WATER
SUPPLY
REQUIREMENTS
Cold water faucet MUST be instaHled within 42
inches (107 cm) of your dryer's water inlet. The
faucet MUST be 3/4 inch (1.9 cm) with thread-
ing for laundry hose connection. Water pressure
MUST be between 30 and 120 psi. Your water
department
can advise you of your water pressure.
,
2.
Turn off COLD water supply to washer,
Remove COLD inlet hose from COLD water
supply and inspect for rubber washer. Replace
washer if it is torn or worn out.
RUBBER WASHER
MUST BE PRESENT
AND UNDAMAGED
COLD INLET HOSE
TO WASHER
3.
Momentarily
turn on COLD supply and run
some water into a bucket or container to clear
any contaminants
in the line.
4.
Remove hose kit from dryer drum and inspect
hose couplings for proper placement of rubber
washers.
RUBBER WASHERS
MUST BE PRESENT
Advertisement
