Advertisement
Available languages
Available languages
Installation
instructions
Performing
lnstalJation
Cycle
FIRE HAZARD
Before operating the dryer, make sure the dryer
area is clear and free of combustible materials,
gasoline, and other flammable vapors. Also
see that nothing (such as boxes, clothing, etc.)
obstructs the flow of combustion and ventilation air.
NOTE
On gas dryers,
before the burner wilt light, it is
necessary
for the gas line to be bled of air. If the
burner
does
not light within
45 seconds
the first
time the dryer is turned
on, the safety switch
will
shut the burner
off. If this happens,
press cancel
and wait 5 minutes
before
making
another
attempt
to light.
With your dryer in final location, perform an installation Cycle to assist in proper installation.
If your dryer has this console:
1.
2,
2a
2b
3
4
Empty dryer's drum and close door.
After you plug in the dryer the first time: wake up the dryer by pressing any button, rotate cycle knob to cycle one
up from lower right position (1), press the 8tart button (3) and then the cancel
button (4).
3. Wake up the dryer again by pressing any button, then immediately and simultaneously
press and hold buttons 2a
and 2b for 5 seconds, or until the LCD display changes.
4. The LCD window will display II1STRL CYCLE and show estimated time of cycle completion.
Press the start button.
The Installation Cycle will automatically
perform various diagnostic routines. At cycle completion,
the LCD window
may display ItfSTRLPRSS_, m eaning your new dryer is properly installed and ready for use. If it prompts an action
such as SER_JICE CORD, N B 5RS or CRLLSE_JtCE877 ff35 32B7, review the installation steps and make the necessary
corrections
before you attempt to use the dryer.
5, Your dryer will exit the Installation Cycle and return to normal operation the next time you wake it up,
Dryer will stay awake for 3 minutes after the Installation Cycle. tf you wish to immediately run the
dryer through a drying cycle, press the cancel button to put the unit to sleep and then rewake it
immediately to continue the normal operating mode.
6. Please read the Use & Care Guide and enjoy your new premium dryer!
If your dryer has this console:
__O
1. After you plug in the dryer the first time: wake up the dryer by pressing any button and follow the prompts on the
LCD User Interface, including language selection.
2. The Installation Cycle will automatically
test for correct cord connection
(on electric models), presence of gas sup-
ply (on gas models) and free flow of exhaust vent. At cycle completion,
the LCD user interface may display INSTRL
PRSSI,meaning your new dryer is properly installed and ready for use. If it prompts an action such as SE_:_JfCE CORD;
fro 6RS or CRLLSERI21CE 877 ff35 3287, review the installation steps and make the necessary corrections
before you
attempt to use the dryer,
3. Your dryer will exit the Installation Cycle and return to normal operation the next time you wake it up,
NOTE
Dryer will stay awake for 3 minutes
after the Installation
Cycle.
tf you 'wish to immediately
run the
dryer through
a drying cycle,
press the cancel
button
to put the unit to sleep and then rewake it
immediately
to continue
the normal
operating
mode.
4. Please read the Use & Care Guide and enjoy your new premium dryer!
Advertisement
