Advertisement
Available languages
Available languages
installation
instructions
7
General
installation
,
,
Connect the exhaust duct to the outside exhaust
system (see pages 5 through 7). Use of a 4" (102
mm) clamp (item A) is recommended to connect
the dpjer to the exhaust vent system. Use metal
foil tape to seal all other joints.
Carefully slide the dryer to its final position.
Adjust one or more of the legs until the dryer is
resting solidly on all four legs. Place a level on
top of the dryer. The dryer MUST be level and
resting solidly on all four legs. Rock alternating
corners to check for stability. Remove and
discard door tape.
IMPORTANT
Be sure the power is off at a circuit breaker/fuse
box before plugging the power cord into an outlet.
3.
Plug the power cord into a grounded outlet.
4.
Turn on the power at the circuit breaker/fuse
box.
5.
Read the Use & Care Guide provided with
the dryer. It contains valuable and helpful
information that will save you time and money.
6.
See the next page about performing a brief,
helpful "installation
Cycle" for your new dryer.
7.
If you have any questions during initial
operation, please review the "Avoid Service
Checklist" in your Use & Care Guide before
calling for service.
8.
Place these instructions
in a location near the
dryer for future reference.
NOTE
A wiring diagram and technical data sheet are
located inside the dryer console.
Advertisement
