Table of Contents
Advertisement
Available languages
Available languages
Operation of Surface Burners
6. Installation
of Burner Cap Assembly
Your range is equipped with any combination of the sealed
burners. Refer to the chart to find your surface burner and
surface burner cap configuration. Be sure to place the correct
burner cap at on all four surface burners.
Possible
surface
burner cooktop
configurations
i¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸
i
iiii :: ! ¸
iiiiii
@
8k
7. Electric
ignition Surface
Burners
Operation of electric igniters should be checked after range
and supply line connectors have been carefully checked for
leaks and range has been connected to electric power.
a.
To check for proper lighting, push in and turn a surface
burner knob counterclockwise
to the LITE position.
You will hear the igniter sparking.
b,
The surface burner should light when gas is available to
the top burner.
Purge air from supply lines by leaving
knob in the LITE position until burner ignites.
Each
burner should light within four (4) seconds in normal
operation after air has been purged from supply lines.
c.
Visually check that burner has lit. Once the burner lights,
the control knob should be turned out of the LITE position.
d,
There are separate electrodes (igniters) for each burner.
Try each knob separately
until all burner valves have
been checked.
Note: Knob styles may vary from those pictured below.
Install the parts shown below at all four surface burner
locations:
1st- Install the surface burner pans (if equipped); 2nd -install
the surface burner heads; 3rd -install the surface burner caps
and 4th; install the burner grates.
Surface
Burner
Grate
iiiii
_
urface
Burner
Cap
OFF ..LITE..hi 6 5 4 3 2 lo
Orifice
Electrode
Removable
Burner
Drip Pan
(on some models)
Advertisement
Table of Contents
