Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Use and Care Manual
iNSTALLATiON
AND SERVICE
MUST BE PERFORMED
BY A QUALiFiED
iNSTALLER.
iMPORTANT:
SAVE FOR LOCAL
ELECTRICAL
INSPECTOR'S
USE.
READ AND SAVE THESE
iNSTRUCTiONS
FOR FUTURE
REFERENCE.
if the information
in this manual
is not followed
exactly,
a fire
or explosion
may
result
causing
property
damage,
personal
injury or death.
FOR YOUR SAFETY:
=
Do not store or use gasoline
or other flammable
vapors
and liquids in the vicinity
of this or any other appliance.
=
WHAT TO DO iF YOU SMELL GAS:
• Do not try to light any appliance.
• Do nottouch
any electrical switch;
do not use any phone
in your building.
• Immediately
call your gas supplier
from
a neighbor's
phone.
Follow the gas supplier's
instructions.
• if you
cannot
reach
your gas
supplier,
call the
fire
department.
=
Installation
and service must be performed
by a qualified
installer, service
agency
or the gas supplier.
Refer to your serial plate for
applicable agency certification
o ALL RANGES
CAN TiP
• INJURYTO
PERSONS
COULD
RESULT
e iNSTALL
ANTI=TIP
DEVICE
PACKED
WiTH
RANGE
• SEE INSTALLATION
iNSTRUCTiONS
Note: For appliances
installed
in the
State of Massachusetts
see page 2.
OVERALL
DiMENSiONS
48"
Maximum
O0
O
O0
Minimum to
Cabinets on
Either Side
1_-13"-_1
Maximum Depth
for Cabinets
Above Range Top.
30"
_
o" Clearance Below Cooking Top and at Rear of Range.
Clearances
and Dimensions
1.
Location--Check
location where the range will be
installed. Check for proper electrical
and gas supply,
and the stability
of the floor.
2.
Dimensions
that are shown
must
be used. Given
dimensions
provide minimum
clearance.
Contact
surface
must be solid and level.
Provide
Proper Fuel Type
Before
Proceeding:
Your range is preset to operate on
natural gas.
DO NOT attempt to convert this range to LP/
Propane settings without the proper LP/Propane conversion
kit provided with the range or obtained from your dealer. Follow
all instructions provided with the LP Conversion Kit.
pin 316259359 En/Fr (0809)
Fran_ais-pages
9-16
Advertisement
Table of Contents
Related Manuals for Crosley CRG3150LBE
Summary of Contents for Crosley CRG3150LBE
- Page 1 iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER. iMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE. if the information in this manual is not followed exactly, a fire or explosion result causing property damage,...
-
Page 2: Important Safety Instructions
Important Notes to the Installer Never leave children alone or unattended Read all instructions contained in these installation in the area where an appliance is in use. As children grow, instructions before installing range. teach them the proper, safe use of all appliances. Never leave Remove all packing material from the oven compartments the oven door open when the range is unattended. -
Page 3: Before Starting
Locate the Bracket Using the Template- (Bracket may Before Starting be located on either the left or right side of the range. Use Tools You Will Need the information below to locate the bracket if template is For leveling legs and Anti=Tip Bracket: not available). - Page 4 Level and Position Range- Level range by adjusting the Connect the range to the gas supply. (4) leveling legs with a wrench. Note: A minimum clearance NOTE: To prevent leaks use pipe joint sealant on all male of 1/8" is required between the bottom of the range and the (outside) pipe threads.
- Page 5 the 1/2" flare union adapter with an adjustable wrench before tightening the gas supplyfitting and/or appliance conduit (Refer to Fig. 4e). Install flare union adapter to external manual shut-offvalve. Attach appliance conduit to flare union on shut-off valve. Make sure service shut-offvalve on pressure regulator is in the "ON"...
-
Page 6: Please Read Carefully
5. Read these electrical connection details first Grounding instructions The power cord of this appliance is equipped with a then connect electricity to range. 3-prong (grounding) plug which mates with a standard Before servicing, disconnect electrical 3-prong grounding wall receptacle to minimize the possibility supply at circuit breaker, fuse or power cord. - Page 7 Test to verify if "LOW" setting should be adjusted 7. Electric ignition Surface Burners Push in and turn control to LITE until burner ignites. Operation of electric igniters should be checked after range Push in and quickly turn knob to LOWEST POSITION. and supply line connectors have been carefully checked for If burner goes out, reset control to OFF.
-
Page 8: Care & Cleaning
10. Air Shutter-Oven Burner 12. Make Sure Range is Level. Level the range by placing a level horizontally on an oven rack. Check diagonally from front to back, then level the range by either adjusting the leveling legs or by placing shims under the corners of the range as needed.