Table of Contents
Advertisement
Quick Links
INSTALLATION
AND SERVICE
MUST BE PERFORMED
BY A QUALIFIED
INSTALLER.
IMPORTANT:
SAVE FOR LOCAL
ELECTRICAL
INSPECTOR'S
USE.
READ AND SAVE THESE
INSTRUCTIONS
FOR FUTURE
REFERENCE.
If the information
in this manual is not followed
exactly,
a fire
or explosion
may result
causing
property
damage,
personal
injury or death.
FOR YOUR SAFETY:
--
Do not store or use gasoline or other flammable
vapors
and liquids in the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL
GAS:
• Do not try to light any appliance.
• Do not touch any electrical
switch; do not use any phone
in your building.
• Immediately
call your gas supplier
from
a neighbor's
phone.
Follow the gas supplier's
instructions.
• If you cannot
reach your
gas supplier,
call the fire
department.
--
Installation
and service must be performed
by a qualified
installer,
service
agency or the gas supplier.
• ALL RANGES
CAN TIP
• INJURYTO
PERSONS
COULD
RESULT
• INSTALL
ANTI-TIP
DEVICE
PACKED
WITH
RANGE
• SEE INSTALLATION
INSTRUCTIONS
Note. For appfiances
installed
in the
state of Massachusetts
see page 2.
RANGE
OVERALL
253/4"
DIMENSIONS
_--
30-1/8"
47-3/4"
Maximum
44 5/8"
Door Open
\\
29 7/8"
----
Clearance
Minimum
if Equipped
2"
with
11000
or
"4_
greater
BTU Burners.
FRONT
SIDE
VIEW
VIEW
t
Minimum
to
1_-13"4_1
. Cabinets
on
Maximum
Depth
18
Either
Side
for Cabinets
/7
of Range.
Above
Range Top.
30-1/8" _J
0" Clearance
Below
Cooking
Top and at Rear of Range.
Clearances
and Dimensions
1.
Location--Check
location where
the range will be installed. Check
for
proper
electrical
and gas
supply, and the stability of the
floor.
2.
Dimensions that are shown must
be used.
Given
dimensions
provide
minimum
clearance.
Contact
surface must be solid
and level.
P/N 316259326 EN FR SP (0309)
Provide
Proper Fuel Type
Before Proceeding: Your range is preset to operate on LP/Propane Gasonly.
Important
Note to the Consumer:
Keep these
instructions
with
your owner's
guide for future reference.
English - Pages 1-8
Fran£ais
- Pages
9-16
Espar_ol-
Paginas
17-24
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Crosley CRP3160GQQA
Summary of Contents for Crosley CRP3160GQQA
- Page 1 INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage,...
- Page 2 Stepping, leaning or sitting on the doors Important Notes to the Installer or drawers of this range can result in serious injuries and Read all instructions contained in these installation can also cause damage to the range. instructions before installing range. Remove all packing material from the oven compartments Do not store items of interest to children in the...
- Page 3 Locate the Bracket Using the Template- (Bracket may Before Starting be located on either the left or right side of the range. Use Tools You Will Need the information below to locate the bracket if template is For leveling legs and Anti-Tip Bracket: not available).
- Page 4 Level and Position Range - Level range by adjusting the (4) leveling legs with a wrench. Note: A minimum clearance of 1/8" is required between the bottom of the range and the leveling leg to allow room for the bracket. Use a spirit level to check your adjustments.
- Page 5 5. Read electrical connection details below Manual Flare Flexible Flare Union Pressure Shutoff Union Appliance Adaptor Regulator and connect electricity to range. Valve Conduit Before servicing, disconnect electrical supply at circuit breaker, fuse or power cord. Electric Requirements: An individual, properly grounded and Service Shut-Off Valve Electric Ignition models only -x polarized branch circuit protected by a 15 amp.
- Page 6 Operation of Surface Burners 7. Electric Ignition Surface Burners Installation of Burner Cap Assembly Operation of electric igniters should be checked after range Your range is equipped with any combination of the sealed and supply line connectors have been carefully checked for burners.
- Page 7 After removing all packing materials and literature from the 8. Adjust the "LOW" Setting of Surface Burner oven: Valve (Linear Flow Valves Only): Set oven to BAKE at 300°F. See Use & Care Manual for operating instructions. Within 60 seconds the oven burner should ignite. Check for proper flame, and allow the burner to cycle once.
- Page 8 If theflameis yellowin color,increase air shutter opening Care, Cleaning and Maintenance size.(See "2" in illustration below.) If the flame is a distinct Refer to the Use & Care Manual for cleaning instructions. blue, reduce the air shutter opening size. To adjust loosen lock screw (see "3" illustration below), If removing range...
Need help?
Do you have a question about the CRP3160GQQA and is the answer not in the manual?
Questions and answers