Crosley CRG3490LSF Installation Instructions Manual

Freestanding

Advertisement

Available languages

Available languages

Quick Links

iNSTALLATiON
AND SERVICE
MUST BE
PERFORMED
BY A QUALiFiED
iNSTALLER.
iMPORTANT:
SAVE FOR LOCAL
ELECTRICAL
iNSPECTOR'S
USE. READ AND SAVE THESE
iNSTRUCTiONS
FOR FUTURE
REFERENCE.
• ALL RANGES
CAN TiP
• INJURYTO
PERSONS
COULD
RESULT
• iNSTALL
ANTI-TIP
DEVICE
PACKED
WiTH
RANGE
• SEE iNSTALLATiON
INSTRUCTIONS
if the
information
in this
manual
is not followed
exactly, a fire or
explosion
may result causing
property
damage,
personal
injury or death.
FOR YOUR SAFETY:
m
Do not store or use gasoline
or other
flammable
vapors and liquids in the
vicinity of this or any other appliance.
=
WHAT TO DO iF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch
any electrical
switch;
do
not
use
any
phone
in your
building.
• Immediately
call your gas supplier
from
a neighbor's
phone.
Follow
the gas supplier's
instructions.
if
you
cannot
reach
your
gas
supplier,
call the fire department.
=
Installation
and
service
must
be
performed
by a qualified
installer,
service
agency
or the gas supplier.
Provide
proper fuel type
Before proceeding: Your range is factory preset to
operate on natural gas. If L.P. conversion is needed,
contact your local L.P. Gas provider for assistance.
The L.P. conversion kit may be located on the lower rear
back panel of the range. If no L.P. kit is provided, contact
your product dealer to obtain the correct L.P. conversion kit.
__
Refer to your serial plate
for applicable agency
certifications
Important
notes to the installer
Read all instructions contained in these installation
instructions before installing range.
Remove all packing material from the oven
compartments
before connecting the gas and
electrical supply to the range.
Observe all governing codes and ordinances.
Be sure to leave these instructions with the consumer.
Important
notes to the consumer
Keep these instructions with your Use & Care Guide
for future reference.
Be sure your range is installed and grounded properly
by a qualified installer or service technician.
Special instructions for ap__pliances installed in the State of
Massachusetts:
This appliance can only be installed in the State of
Massachusetts by a Massachusetts licensed plumber or
gas fitter. When using a flexible gas connector, it must not
exceed 3 feet (36 inches) in length. A "T" handle type
manual gas valve must be installed in the gas supply line to
this appliance.
IMPORTANT
SAFETY INSTRUCTIONS
Installation of this range must conform with local codes or,
in the absence of local codes, with the National Fuel Gas
Code ANSI Z223. l--latest
edition when installed in the
United States.
When installed in a manufactured (mobile) home,
installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280
[formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD (Part 280)] or, when
such standard is not applicable, the Standard for
Manufactured Home Installations, ANSI/NCSBCSA225.1,
or with local codes.
This range has been design certified by CSA International.
As with any appliance using gas and generating heat, there
are certain safety precautions you should follow. You will
find them in the Use & Care Guide, read it carefully.
p/n 316903001 (1005)
1

Advertisement

Table of Contents
loading

Summary of Contents for Crosley CRG3490LSF

  • Page 1 iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER. iMPORTANT: SAVE FOR LOCAL ELECTRICAL for applicable agency certifications iNSPECTOR'S USE. READ AND SAVE THESE Refer to your serial plate iNSTRUCTiONS FOR FUTURE REFERENCE. Important notes to the installer • Read all instructions contained in these installation instructions before installing range.
  • Page 2: Important Safety Instructions

    iMPORTANT SAFETY iNSTRUCTiONS DO NOT MAKE ANY ATTEMPT TO OPERATE THE ELECTRIC IGNITION OVEN DURING AN Be sure your range is installed and grounded ELECTRICAL POWER FAILURE. RESET ALL OVEN properly by a qualified installer or service CONTROLS TO "OFF" IN THE EVENT OF A POWER technician.
  • Page 3: Tools You Will Need

    Tools you will need Tools (Wear safety glasses when using tools): For leveling legs and Anti-Tip Bracket: • Adjustable wrench or channel lock pliers (Fig. a) Fig. e Fig. a • 5/16" Nutdriver or flat head screwdriver (Fig. b) • Electric drill &...
  • Page 4: Installation

    Installation with cabinets Check location where the range will be installed for proper electric and gas supply, and stability of the floor....The dimensions shown here must 30" --q-___ _ be used and are minimal unless otherwise stated. These 18"...
  • Page 5: Important Safety Warning

    Install anti-tip bracket FASTEN BRACKET (FLOOR MOUNTING ONLY) _-- More Than IMPORTANT SAFETY WARNING ! Leveling Leg -- 1=1/4" To reduce the risk of tipping of the range, the range must be secured to the floor by properly installed anti= tip bracket and screws packed with the range.
  • Page 6: Provide An Adequate Gas Supply

    Provide an adequate gas supply. Connect range to gas supply. Please note: Operation at elevations above 2000 ft., Note: To prevent leaks use pipe joint sealant on all male appliance rating shall be reduced at the rate of 4 percent (outside) pipe threads.
  • Page 7: Checking Manifold Gas Pressure

    Tighten the gas supply fitting and/or appliance conduit Checking manifold gas pressure to flare union adaptor on the right side of the pressure Do not use flame to check for gas leaks. regulator (refer to Fig. 10) using NO MORE THAN 15ft./Ibs.
  • Page 8 Read the following electrical Check burner cap placement. connection details before It is very important to be sure that all surface burner caps connecting electricity to range. and burner grates are properly installed and in the correct locations before operating the appliance. Please note that Before servicing, disconnect electrical the burner heads are secured to the cooktop.
  • Page 9: Check Ignition Of Surface Burners

    Check ignition of surface burners. Operation of electric igniters should be checked after range and supply line connectors have been carefully checked for leaks and range has been connected to electric power. To check for proper ignition, push in and turn a surface burner knob counterclockwise to the LITE other surface...
  • Page 10: Make Sure Range Is Level

    Adjust air shutter - lower oven. Make sure range is level. To determine if the oven burner flame is proper, remove the Level the range by placing a level horizontally on an oven oven bottom panel and lower burner baffle (Refer to Fig. rack.
  • Page 11 L'INSTALLATION ET L'ENTRETIEN DOiVENT ETRE REALIS#S PAR UN INSTALLATEUR QUALIFI#. Reportez-vous _ la plaque iMPORTANT : CONSERVEZ CES iNSTRUCTiONS EN signal6tique pour connaftre PRl_VlSION D'UN USAGE #VENTUEL PAR les certifications reconnues. L'INSPECTEUR EN #LECTRICITE DE VOTRE LOCALITI e. VEUILLEZ LIRE ET CONSERVER CES iNSTRUCTiONS POURVOUS Y REPORTER ULT#RIEUREMENT.
  • Page 12 IMPORTANTES MESURES DE S¢:CURITE N'ESSAYEZ PAS DE FAIRE FONCTIONNER LE FOUR AALLUMAGE I_LECTRIQUE • Verifiez que votre cuisiniere est installee et raise & la terre DURANT UNE PANNE D'I_LECTRICITI_. REMETTEZ TOUTES de fagon appropriee par un installateur qualifie ou un LES COIVlMANDES DU FOURA LA POSITION _ OFF _ technicien de service.
  • Page 13 Outils n6cessaires Outils (Portez des lunettes de s6curit6 Iorsque vous utflisez les outils) : Pour rajustement des pieds de raise _ niveau et rinstallation du support anti=renversement • CI6 _ molette ou pince multiprise ordinaire (fig. a) Fig. e Fig. a •...
  • Page 14 Installation avec des armoires V6rifiez II'alimentation 61ectrique, I'alimentation en gaz et la stabilit6 du plancher _ I'endroit oO la cuisini_re sera install6e. Sauf avis contraire, les dimensions indiqu6es ici sont des dimensions minimales et doivent 30 po -____ _tre utilis6es. Ces mesures ne pr6voient 30 po aucun d6gagement sous la surface ou...
  • Page 15: Fixation Du Support

    Installer le support anti-renversement FiXATiON DU SUPPORT (SUR LE PLANCHER SEULEMENT) AVIS DE SECURITE IMPORTANT! lus de Pied de raise -- niveau (t-tl4 Afin de r_duire les risques de renversement, la cuisiniere dolt 3,2 em _tre fix_e au plancher de fa_on appropriee au moyen du support anti=renversernent et des vis fournis avec la cuisiniere.
  • Page 16 Raccorder la cuisini re la conduite Pr6voir une alimentation en gaz adapt6e d'alimentation en gaz Remarque : Si I'altitude est sup6rieure _ 610 m (2 000 pi), les Remarque : Pour Oviter les fuites, utilisez de la pbte b joint pour caract6ristiques nominales de I'appareil doivent _tre r6duites...
  • Page 17 c. Serrez l eraccord d 'alimentation engazoulaconduite de V6rifier la pression de gaz au collecteur I'appareil enle branchant _ I'adaptateur deraccord-union setrouve duc6t6 droit d ud6tendeur (voir f ig.10)SANS N'utilisez pas de flamme pour d_tecter SERRERA les fuites de gaz. PLUS DE 15 pi/Ib.
  • Page 18 Life les consignes suivantes sur le V rifier le positionnement branchement 61ectriq ue chapeau de breleur avant de brancher la cuisini re. II est tr_s important de vdrifier que tousles chapeaux et toutes les grilles br_leurs de surface sont correctement installds Avant d'effectuer...
  • Page 19 V6rifiez rallumage des br leurs surface. Apr_s vous 6tre assur6 que la cuisini6re et les raccords de la conduite d'alimentation ne pr6sentent aucune fuite, branchez la cuisini_re _ I'alimentation en 61ectricit6 et v@ifiez le fonctionnement des allumeurs 61ectriques. a. Pour v@ifier I'allumage, poussez et tournez le bouton de I'un des br_leurs de surface darts le sens contraire des aiguilles Autres...
  • Page 20 R6gler robturateur d'air du br leur V6rifier que le four est de niveau inf6rieurdu four Mettez le four _ niveau en plagant un niveau _ I'horizontale sur une Pour d6terminer si la flamme du brGleur du four est correcte, grille du four. V6rifiez en diagonale de I'avant vers I'arri_re, puis mettez enlevez la sole du four et le d6flecteur (voir fig.

Table of Contents