Table of Contents
Advertisement
Installation Instructions
A. RECIRCULATING
(Non-Vented Ductless)
INSTALLATION
OVERVIEW
A1. Attach
Mounting
Plate to Wall
A2. Prepare Top Cabinet
A3. Mount the Microwave
Oven
÷
AI.__. A TTACH THE MOUNTING
PLATE
TO THE WALL
- ,,,,,_
===e
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud.
1, Remove
the toggle wings from the bolts.
2. Insert the bolts into the mounting
plate through
the holes designated
to go into drywall and
reattach the toggle wings to 3A" onto each bolt.
To use toggle
bolts:
Spacing for Toggles More
Than Wall Thickness
i
Toggle Wtngs
Mounting
Plate _
Wall
Bolt End
3.
Place the mounting
plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE:
Before tightening
toggle bolts and wood
screw,
make sure to coincide
bottom line of the
Mounting
plate with Horizontal
line of "Rear wall
Template"
and then the Mounting
plate is properly
centered
under the cabinet.
CAUTION:
Be careful to avoid pinching
fingers
between the back of the mounting
plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
A2._..USE TOP CABINET
TEMPLATE
FOR PREPARATION
OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
•
Read the instructions
on the TOP CABINET
TEMPLATE.
•
Tape it underneath
the top cabinet.
•
Drill the holes, following
the instructions
on the
TOP CABINET
TEMPLATE.
CAUTION:
Wear safety goggles
when drilling holes
in the cabinet
bottom.
12
Advertisement
Table of Contents
