Connecting Inlet Hoses; Water Supply Requirements - GE GTDS825GD0MC Installation Instructions Manual

Installation Instructions
[] CONNECTING INLET HOSES
(on some models)
To produce steam, the dryer must connect to the cold
water supply. Since the washer must also connect to the
cold water, (] "Y" connector is inserted to allow both inlet
hoses to make that connection at the some time.
NOTE: Use the new inlet hoses provided; never
use old hoses.
1. Turn the cold water faucet off. Remove the washer inlet
hose from the washer fill valve connector (cold).
2. Ensure the rubber fiat washer is in place end screw the
female coupling of the short hose onto the washer fill
valve connector. Tighten by hand until firmly seated.
3. Attach the female end of the "Y" connector to the
mole coupling of the short hose. Ensure the rubber fiat
washer is in place. Tighten by hand until firmly seated.
"Y" Connector
\
4. Insert the filter screen in the coupling of the washer's
inlet hose. If (] rubber fiat washer is olre(]dy in place
remove it before installing the filter screen. Attach this
coupling to one mole end of the "Y" connector. Tighten
by h(]nd until firmly seated.
5. Ensure the rubber riot washer is in place and ott(]ch the
dryer's long inlet hose to the other mole end of the "Y"
connector. Tighten by h(]nd until firmly seated.
6. Ensure the rubber riot washer is in place and attach
the other end of the dryer's long inlet hose to the fill
v(]lve connector at the bottom of the dryer back panel.
Tighten by hand until firmly seated.
!!
I_ CONNECTING INLET HOSES (cont.)
7. Using pliers, tighten (]ll the couplings with on (]ddition(]l
two-thirds turn.
NOTE: Do not overtighten. Damage to the couplings may
result.
8. Turn the water faucet on.
9. Check for le(]ks (]round the "Y" connector, f(]ucet (]nd
hose couplings.
WATER SUPPLY REQUIREMENTS
Hot (]nd cold w(]ter f(]ucets HUST be inst(]lled within 42
in. (107 cm) of your w(]sher's water inlet. The f(]ucets
MUST be 3/4 in. (1.9 cm) g(]rden hose-type so inlet hoses
c(]n be connected. W(]ter pressure MUST be between 10
(]nd 120 pounds per squ(]re inch. Your w(]ter deportment
c(]n advise you of your water pressure.
NOTE: A water softener is recommended to reduce
buildup of scale inside the ste(]m gener(]tor if the home
w(]ter supply is very h(]rd.
REGISTERYOUR NEW APPLIANCE TO RECEIVEANY
IMPORTANT PRODUCT NOTIFICATIONS.
Please go to www.GEApplionces.com or moil in your
Product Registration Cord.
For questions on inst(]ll(]tion, c(]ll: 800.626.2000 (US) or
800-561-3344 (C(]nod(]).