GE GTDS825GD0MC Installation Instructions Manual page 15

Installation Instructions
_ Remove and swap the cover cap and door handle from
the outer door:
A. Squeeze the tabs on the inside of the door handle
clips. Push clips through the outer door.
B.Squeeze the tabs on the inside of the cover cap.
Push cap through the outer door.
Cover
strip
Inside of door
/
Door handle
Door handle clip
C. Push the door handle clips into the openings on the
opposite side of the outer door making sure you flip
the handle so it curves to the inside.
D. Push the cover cap into the openings on the outer
door where the handle was removed.
Inside of door
!
I
I
_'_>_4,._ Inside of door
Cover strip j _
_When the cover cap and door handle in place, mount
the inner door back into the outer door with the screws
removed in step a,.Make sure you mount the hinges on
the side opposite the handle.
I
I
Inside screws
Door hinge
screws
screws
-Handle
_ iVlount the assembled door on the 2 upper left side hinge
screws installed in step 2.
Move the hinge screws loosened in step 3 into the lower
left side screw holes and firmly tight all q screws.
Door
_ior and
_@)_ tighten screws
_ Install the/4 plastic caps removed in step 1 into the q
right side front panel holes.
NOTE:To return the door to the original setup, follow
threse instructions, swapping "left" and "right".
15